Burner accessories

116 companies | 300 products
rotor mixer
rotor mixer
TDS

Engine power: 5.5 kW - 25 kW

YSTRAL TDS-Induction Mixer TDS Induction Mixers draw powder, liquids or gases below their level into liquids and at the same time homogenise the contents of the container. The vacuum required for induction is generated in the mixing head. ...

butterfly valve
butterfly valve
DESPONIA®

DN: 25 mm - 1,600 mm
Pressure: 0 bar - 16 bar
Temperature: -20 °C - 200 °C

Centric butterfly valve with an elastomer liner, available as wafer, lug or U-section type. Engineered and manufactured for more than 30 years in Spain, Desponia® is built for long-lasting use in highly demanding environments up to 16 ...

turbine mixer
turbine mixer
VSF

VSF Side-Entry Mixer Designed for Flue Gas Desulfurization Absorber Service Features • Purpose-Built product for Absorber • Mechanical Seal - No seal water required - Cost savings (water usage) • A312 hydrofoil impeller ...

paddle blender
paddle blender

The CO2 Series of our highly regarded blenders provides rapid cooling with a direct bottom CO2 injection. Our superb Dual Shaft CO2 Blender includes valves at each injection point. Plus, this Dual Shaft CO2 Blender includes the stainless ...

static mixer
static mixer
CSE-X® series

Laminar mixing processes are based on the repeated separation of the flow into layers, followed by redistribution and recombination parallel to the flow direction. The number of layers, and hence the homogeneity, increases with each additional ...

static mixer
static mixer
Aquamix

Static mixers can significantly reduce the time required for mixing processes if the flow in the tube is turbulent. Special mixing elements are used here to form the vortex. Mixing and homogenisation take place in the downstream mixer ...

static mixer
static mixer
CSE-V

Insoluble media can be easily dispersed or contacted with the help of static mixers. Static mixers are ideal for washing, reaction and mass transfer processes. They can be designed and built for both laminar and turbulent flows such that ...

IR flame detector
IR flame detector
RFD-6X

RFD-6X is a Triple IR (IR3) Flame Detector. Identify fire by analyzing the IR wavelengths of a flame. Maximum 50 meters of detection range with a 90 degree cone of vision. Permits operation at Hazardous areas. User selectable output ...

See the other products
REZONTECH
IR flame detector
IR flame detector
RFD-5X

RFD-5X is a UV/IR type Flame Detector. Identify fire when both UV and IR sensors simultaneously detect the presence of a flame. Maximum 30 meters of detection range with a 90 degree cone of vision. Permits operation at Hazardous ...

See the other products
REZONTECH
IR flame detector
IR flame detector
RFD-3000X

RFD-3000X is a Triple IR (IR3) Flame Detector with international certifications. Identify fire by analyzing the IR wavelengths of a long distance flame.  Maximum 60 meters of detection range with a 90 degree cone of vision. Permits ...

See the other products
REZONTECH
IR flame detector
IR flame detector
40/40I

Crowcon offers a range of infra-red (IR) and ultra-violet (UV) based flame detectors for quickly detecting flames at a distance. Depending on model, this includes a variety of gas and fuel fires including those generated from hydrocarbons, ...

shut-off valve
shut-off valve
VMH series

DN: 65 mm - 300 mm
Pressure: 0 mbar - 1,600 mbar
Temperature: -15 °C - 60 °C

VMH Safety shut off valves, slow opening and fast closing with hydraulic or pneumatic actuator The VMH type valve is a safety shut off valve for gaseous media operated by hydraulic actuator. It is suitable for gas blocking and releasing ...

See the other products
Elettromeccanica Delta S.p.A.
butterfly valve
butterfly valve
DN 500, 450 ... 500 °C | GD, S series

series GD6 DN 500 Coupling with electric gear motor. Design temperature 600° C, operating temperature 450 - 500° C.

boiler economizer
boiler economizer

Energy saving and efficiency are key factors for modern industry. One of the most significant energy users in a typical production facility is the steam boiler and, therefore, investing in energy saving equipment should always provide ...

See the other products
Babcock Wanson
boiler economizer
boiler economizer
Aalborg XW

is a water tube, forced circulation exhaust gas boiler/economizer. It is specially designed for heat recovery from diesel engine exhaust gas but the basic design suits numerous applications. The Aalborg XW constructed with water tubes ...

needle valve
needle valve
CP-06

DN: 0.25 in - 0.5 in
Pressure: 0 bar - 420 bar
Temperature: -20 °C - 400 °C

The CP-06 offer a wide array of needle valves that are specifically constructed to be applied with liquids that both posses high pressure and temperature service. Fabricated from AISI-36 stainless steel, these valves' back-seated stem ...

turbine agitator
turbine agitator
HWL

Engine power: 3 kW - 90 kW

Proven Reliability - World's Most Sold FGD Agitator The EKATO HWL FGD Side-Entry agitator was specially designed to be used in absorber towers of flue gas desulfurization plants. The agitators are designed and manufactured for fatigue ...

economizer
economizer

Frick® DX Economizers are compact shell and tube heat exchangers. A small amount of high pressure liquid is flashed to an intermediate pressure inside the tubes where it is evaporated to chill the main stream of high pressure liquid passing ...

pilot burner
pilot burner
ECO 2 G C 2

Power: 60 kW - 4,070 kW

Two-stage operation, Ability to operate with natural gas and LPG fuel, Ability to operate at 300 mbar and 21 mbar gas pressure up to model ECO 55 GC 2, Wide thermal capacity adjustment range according to the heat requirement, Direct ...

See the other products
Ecostar Burners
burner igniter
burner igniter
Firebox

VoltageV230 PowerW1000/1500 FrequencyHz50/60 Max. temperature°C700 Heater tubemmØ 31,5 Air inletmmØ 38 Size (l x w x h)mm335 x 85 x 85 Weightkg1,1

igniter
igniter

Oxy-Fuel Options Auto Ignitor Safely ignite oxy-fuel torches with the convenience of never having to leave operator station

economizer
economizer
AM-53 series

The economizer is generally used in those pneumatic equipments which require energy saving. The economizer with G1/8 to G 1 connections functions as a pressure reducer, in one direction, with 1 to 5 bar regulation, and has free return ...

metal ignition electrode
metal ignition electrode

99.9999% Pure medical grade magnesium electrodes. NO ALLOYS! 12" X 2" (4mm thick)

See the other products
Ancient Water Restoration Incorporated
butterfly valve
butterfly valve
PKIII/D

DN: 300 mm - 3,000 mm
Pressure: 0 bar - 2.5 bar
Temperature: -25 °C - 300 °C

SAFETY QUICK-CLOSING BUTTERFLY FLAP VALVE Being part of the proven KÜHME high-performance valve series for industrial applications, the PKIII type is used in any application where safe and quick shut-off of gaseous media is required. ...

dynamic mixer
dynamic mixer

Jongia meets the challenge of modern-day high productivity requirements with its novel gas-inducing system. In a reactor a gas-inducing coil, the so-called sparger, is installed for the primary gas supply. The unused gas is collected ...

boiler economizer
boiler economizer

rotor agitator
rotor agitator
BPC® Move

Capacity: 2, 1, 0.5 l

BPC® Move is a compact standalone mechanical agitator ideal for easy, reliable mixing, dispersion and dissolution of particle-free solution and slurries. It combines the strength and reliability of mechanical agitation with the ease-of-use ...

UV flame detector
UV flame detector

The SENSE-WARE UV Flame Detector utilizes a microprocessor for sophisticated electronic signal analysis. The ultraviolet flame detector is suitable for indoor and outdoor applications. Because of its non-corrosive housing it is suitable ...

custom heater
custom heater

Resistencias Tope, with more than 60 years of experience in manufacturing and designing heating elements, offers the most complete line of tubular heaters.

See the other products
Resistencias Tope S.A.
exhibit your products

& reach your clients in one place, all year round

Exhibit with us