Other electric power supplies and equipment

Frequency Range - 698-2700 MHz Insertion Loss - <0.05dB Impedance - 50 Q Average Power, Maximum - 500 W Peak Power, Maximum - 3 KW PIM - <-150d Bc@2*43d Bm Connector - 7/16 DIN Female Operating Temperature - -30-+75°C Relative ...

Floor space can be one of the most valuable assets in the workshop. Make sure yours is as clean and tidy as possible with the Bead Bazooka® Changing Station. This stand gives you the perfect place to keep your Bead Bazooka® safe and out ...

ITR500-002 has 4 channel 1.5A dimming capability. It has short circuit, over load and heat protection. ITR500-001 can dimming from 0V to 10V for per channel. The outputs for MAX 10A be switched ON or OFF on every output channel, also ...

Hydrogenics is pioneering Power-to-Gas—an innovative energy conversion and storage solution using electrolysis. It integrates renewable sources of generation, converts surplus electricity to produce hydrogen or renewable gas, and leverages ...

Output voltage: 12, 24, 90 V
Power: 250, 200 W

Storch D.C. Power Supplies are available in four types with various levels of output to let you control electromagnetic forces with precision, just as your application demands. NEMA 12-J.I.C. oil tight, industrial type enclosures are ...

Grandway provides a high precise PLC splitter for the construction of optical network. Low requirements of placing position and environment, compact micro type design. It is especially suitable for tiny room installation and can be easily ...

This device splits the analog input into two output, identical to the input signal and in the same time it makes a galvanic isolation. The Isolated splitter is usually used in automation systems, where the analog signal of a measurement ...

WOS CD is intended for systems, where amount of generated condensate exceeds capacity of single largest available WOS water oil separator. WOS CD can evenly distribute collected condensate between up to three WOS 35 water oil separators. ...

The electronic heat cost allocator caltos E with integrated radio interface serves to record the share of heat produced by radiators. The electronic heat cost allocator caltos E with its many possible uses and its convenient recording ...

Input voltage: 200 V - 240 V
Output voltage: 0 V - 240 V
Current: 0 A - 30 A

This bipolar current-controlled power supply has been optimized for use with our thermoelectric heat exchanger. Current Customer Applications Paired with Cleanstream of Terraview thermoelectric heat exchangers to control temperature ...

Adaptor Box is an External Battery with Charger. This can be connected to the scale externally. The scale can be used where electricity is not available. The Adaptor Box can be disconnected and charged as it is portable.

Input voltage: 90 V - 264 V
Power: 30 W

Highly reliable, 30W wall-mounted style single-output interchangeable adaptor, which is compact and convenient for carry. This product is equipped with an interchangeable AC plug (4 types, including European type, USA type, U.K. type ...

Charles Fiber Rack Solutions (CFRS) provide flexible, multi-functional panels for patch, splice and splitter requirements within virtually any application. The efficient design of the splice area and bulkhead allows for maximum density ...

-Energy-efficient temperature control in the high temperature range without pressure surges -Flexible and modular use with all standard REGLOPLAS temperature control units for applications with water up to 200 °C -Mould-adjacent ...

Input voltage: 15 V - 28 V

Supplying regulated power source by the battery and power stabilizing circuit. Supplyingpowersourceforsensorsand other devices. Usingas UPS (Uninterrupt Power Supply) with current power supplying device. Rechargeable byAC/DC power ...

Input voltage: 90 V - 250 V
Output voltage: 24 V
Current: 10 A

The PSM-5000 power supply module is designed to be inserted into the RMC- 5000 rack mount chassis. The module provides an operating voltage through the chassis backplane to power up to sixteen fiber optic module cards. Each rack mount ...

EEVC 7KW single-phase AC wallbox is a new generation of intelligent products launched by Aswich solve the pain points of home charging. Its appearance of this product adopts a streamlined and simple design, which is more refined and glitzy. Product ...

Output voltage: 0 V - 12 V
Current: 0.5, 25.6 A

3U PXI High Voltage DPS • 16-bit source/18-bit measure resolution • 0 ~ +12 V per channel • 8 DPS / 0.5A per channel • 8 CHs V/I pulsing output • 16-CH Relay Outputs • 8-CH digitizers designed • 8-CH 18-bit high resolution A/D ...

Most optimal Filling Adapters for Engine Oils, AC Gas, Radiator Coolant and more… With over 20 years of expertise in developing filling solutions for the automotive industry, Twin Engineers understands the needs and challenges on the ...

Economy condensate distributor The PURO-CT-DISTRIBUTOR is designed to distribute condensate into two or three oil/water separators. This way you can combine more PURO-CT units to match up against larger compressor systems. As condensate ...

This passive optical spltter comes in two versions, BarnMini-08-1:2 and BarnMini-08-1:4. It is a great supplement in smaller BarnMini systems, but can also be used in more advanced BarnOne configurations. As with any of our other BarnMini ...

Input voltage: 100 V - 375 V
Output voltage: 12 V
Current: 0.83 A

Rated power output 10 W; Rated output voltage; Cover- plastic, modular, for distribution boards and distribution boxes, indicator of output voltage presence Technical info • Direct mounting on 35 mm rail mount acc. to EN 60715 • ...

The Digital Signage products DP1.2-Splitter are stand-alone products and distribute one DisplayPort video signal to multiple displays. Video Distributes DisplayPort™ 1.2 video signals up to 2 displays Resolution with pixel rates ...

Input voltage: 100 V - 240 V
Output voltage: 24 V
Power: 96 W

● Universal AC input ● Overload protection ● High power density ● Over voltage protevtion ● Compact designer ● Short circuit ...

Input voltage: 9 V
Output voltage: 18 V
Current: 2 mA

Single channel battery power supply for accelerometers and piezo velocity transducers, BNC input/output Sensor Supply Current: 2 mA Compliance Voltage: 18 VDC Sensor Connector: BNC Jack Power Source: 9 V Batteries ...