Amplifiers

Voltage: 50, 2 mV
Current: 4 mA - 20 mA

AMPLI-Block is a load cell/transducer amplifier. AMPLI-Block offers many benefits in a compact design such as very easy set up and two outputs (one with adjustable filter). AMPLI-Block may be used with one or two load ...

... ratio · Broad frequency response DC to 10 k Hz (913C) Features The DPM-900 Series is a Dynamic Strain Amplifier. The carrier-wave amplifier features highly accurate, excellent stable, and easy setting.

... gauge amplifier with up to 8 measuring channels • - Connecting with different kind of strain gauge sensors • - Complete system solutions through networking of devices via CANopen Applications • - Universal usable ...

Frequency: 100 kHz

... structure and convenient maintenance. The power amplifier uses several power units to work in parallel. The method is flexible and flexible. Users can increase or decrease the power module and power amplifier ...

Frequency: 0 Hz - 10,000 Hz

Features: * Indicator for voltage and current output * Indicator for output signal * Output current can be adjusted from 2A to 10A * Hot protect for output transistor * Indicator for output transistor invalidation * Constant current ...

Voltage: 10 V
Current: 4 mA

The TSVA2-DGM is a 2-channel vibration amplifier that is used in connection with our broad bandsensor BV100 A Montronix SPECTRA™ controls the TSVA2-DGM via an RS485 interface. This enables you to set individual ...

Voltage: 9 V - 30 V

The digital Load Cell Amplifier in junction box DBB is a combination of cable box and an analog-to-digital converter. The internal high-precision digital amplifier with 24-bit A/D converter converts the ...

Voltage: 5 V

... class of 0.0025 the CFA225-P is at same time the smallest, most accurate and cost-effective carrier frequency strain-gauge amplifier. In accordance with the prior art, the carrier frequency offers the most accurate traceability ...

Power: 1 W

DT-730: DVB-T 30 dBm Power amplifier (1 W) The DT-730 is a high quality 1 W RF power amplifier for COFDM signals, both for single carrier or multicarrier system. The system provides an amplified output ...

Current: 50 A

The CGS-MV_I card is a precision DC measurement amplifier module (limited AC measurement). It is designed to measure, depending on the shunt resistor, up to 50 A continuously. The typical accuracy is 0.05 % with resolutions ...

Ampli Light & Sound System Together with the instruments of quality control, we provide systems of signal amplification in order to make it easier for the operator the management of non-compliance. With these systems it is possible, ...