Calibrators

Temperature: 10 °C - 40 °C
Pressure: 10 bar

The ZELTWANGER leak calibrator is used to test and configure leak testing devices. For this purpose, the leak calibrator is connected to the device leak simulation and the required leak rate, depending ...

For the calibration of welding units according to DIN EN 1090, IEC 60974, EN 50504, DVS 3009. The periodical calibration of welding units is a requirement to guarantee reproducible welding results and a production according to certificated ...

... e.K. CAL200 calibrator class 1 PTB CR514 calibrator class 2 51AB Phase Calibrator VC20 Vibration Calibrator VC21 Vibration Calibrator 394C06 ...

Temperature: 0 °C - 50 °C
Pressure: 0 psi - 750 psi

... Pressure Calibrator The SPC4050 pressure calibrator is designed to provide automated calibration of Scanivalve DSA, ZOC, and MPS series pressure scanners. The calibration system consists ...

Temperature: 33 °C - 300 °C

... portable instrument designed to provide quick and accurate calibration of thermocouple and RTD temperature probes. The probe calibrator is managed by a temperature controller system, incorporating a heater and a precision ...

The Air sampler calibration instrument is mainly used to calibrate all microporous plankton samplers. It can quickly and accurately measure the flow of the sampler without increasing the load of the sampler, resulting in a large deviation ...

The Hydraulic Calibration System is specially designed for the calibration of load cells with higher capacity. The Calibration for Load Cell can calibrate the load cell within ±1%. The load frame is with four columns. ...

NBJS-100/200/300/500/1000N.m Torque Wrenches Standard Machine/Calibrator DETAIL 1. Introduction →Used in measurement, calibration and verification for torque wrenches, torque screwdrivers or other appliance (torque ...

The WrenchLoader from Crane works by simulating the conditions of a particular Torque application, allowing the user to test Torque wrenches by measuring the Torque applied, via a Transducer, allowing the wrench to be calibrated with ...

Check device for HP and HPE II In compliance with ISO 9000 the user is obliged to a regular control of his measuring equipment. With the check device the accuracy of Shore hardness testers is controlled. It allows a quick control ...

LSI’s Ultra Torque Wrench Calibration System is one of the most flexible and easy-to-use torque tool testers available. Accuracy better than ± 0.2% of reading from 10-100% full scale RS 232 and USB capability ...

Ordinary calibration device for a quick testing of strain gauge amplifiers. Setting: ± 0.5, ± 1, ± 2, ± 5, ± 10, ± 20 mV / V Polarity switch Full, half and quarter bridges 120 and 350 ohms, selectable via rotary ...

The StreamLine Pro Automatic Calibrator facilitates fast and accurate calibrations of probes over a large velocity range (0.02 m/s to > 300m/s) in direct connection with experiments. Clean and dry air from a pressurised ...

FEATURES: Every gauge carries a calibration certificate giving actual values Module 1A, Module 2A giving the most economical solution to your inspection needs on shop floor High pressure system: high speed of response and ...

Compact, Portable, and Convenient Calibration Kit The Grace Instrument M3010 Weight Calibration Kit works in conjunction with the Grace Instrument M3600 Rheometer and M3400 Manual Dial-Reading Viscometer. Calibration is a method used ...