Discharge pumps

Flow: 0.021 m³/h - 0.106 m³/h

... medium for hydraulic diaphragm pulsing and the best medium for gear lubrication. The results are better pump performance and longer pump life. Simplex pump but can be field converted ...

... Sprague hydraulic pumps move relatively large flows of liquids at low to moderate pressures. The pumps deliver liquid with each up and down stroke of the liquid piston rather than, only with a down stroke ...

Flow: 15, 2, 10, 9, 4 l/h
Pressure: 18, 3, 10, 9 bar
Power: 36 W

SOL 201 Multifunction digital solenoid pump with stroke adjustment. Multifunction dosing pump. Mechanic adjustment of each injection Microprocessor, display and digital control technology Proportional ...

Flow: 0 m³/h - 4,000 m³/h
Pressure: 0 bar - 100 bar
Head: 0 m - 220 m

... abandon of mechanical seal pumps). Design features Pumps of the series CN MAG-M are horizontal single-stage volute casing pumps It is a modular configuration of either bare shaft ...

Flow: 0 us gal/min - 100 us gal/min
Pressure: 0 psi - 60 psi

... friction radial water flow. • Noryl® impeller-diffuser assemblies are encased in a corrosion resistant stainless steel shell. • Pump and motor assembly are corrosion resistant. • Efficient operation in either horizontal ...

Flow: 3,200 m³/h
Pressure: 90 bar
Head: 480 m

... overhung process pump, designed and built in accordance with the latest edition of API 610 (OH2 type), and with over 130 hydraulic combinations available. Overview Designed for all fluids and process conditions, the ...

Flow: 0.6 m³/h - 15 m³/h
Pressure: 70 bar - 120 bar
Power: 15 kW - 75 kW

High Pressure Plunger Pump The RONO high pressure plunger pump is a triplex piston pump and is used to convey various edible fat products through multipurpose process lines. The pump ...

Flow: 580 m³/h
Pressure: 14 bar

... load is small, wear is small, pump efficiency is high. The pump is equipped with a safety valve as overload protection. The full return pressure of the safety valve is 1.5 times the rated discharge ...

Flow: 50 m³/h
Pressure: 30 bar

The Mono borehole pump is the essence of simplicity in design. The simple positive displacement, Mono designed rotor and stator are immersed below draw-down level in the bore or well. Mono Borehole pumps ...

Flow: 0 m³/h - 550 m³/h
Pressure: 10 bar - 16 bar
Head: 0 m - 105 m

... • TKF-M series pumps has designed for pumping non-abrasive and small particulars liquids. • Pump diamensions are acceptable TS EN 733 standard. • Suction and discharge ...

Pressure: 130 bar

Supplied in standard in warm box and cold box execution the VP pumps can be directly mounted on the ASU cold box and remain in cold standby. They integrate all the necessary safety devices for safe operation in continuous ...

Flow: 12.6 m³/h - 5,400 m³/h
Pressure: 0.6 bar - 7 bar
Head: 6 m - 68 m

SH pump series are horizontal, cantilevered, single-stage centrifugal pump. It is designed for pumping tough slurries which is high-abrasive or corrosivre and high-density. The horizontal pumps ...

Flow: 25 l/min
Pressure: 6 bar

51114 Pneumatic 1:1 – piston pump, suitable for the suction and the transfer of petrol. The pump is equipped with an earth cable to enable an electrostatic discharge and is constructed ...

Flow: 2 m³/h - 850 m³/h
Pressure: 10 bar
Head: 2 m - 100 m

... connected to the pump by an adaptor and a flange. • Motor shaft is joined to pump shaft by a special clamp. In the case of motors with power over a certain value the pump and the motor ...

Flow: 0 l/min - 400 l/min
Head: 0 m - 18 m
Power: 0.25 kW - 1.1 kW

... between EVOLUTE magnetic drive and mechanical seal pump FEATURES • Tilt lid with swing bolts closure system • Magnetic drive or mechanical seal pump • Solid Polypropylene base with discharge ...

Flow: 0 m³/h - 500 m³/h
Head: 0 m - 150 m

Kirloskar GK(P) pumps are used for handling various types of chemical liquids. These pumps are manufactured to close tolerance and are of rigid construction. GK(P) pumps are mainly used ...

Flow: 39 m³/h - 390 m³/h
Head: 42 m - 105 m
Power: 5.5 kW - 95 kW

Close coupled pumps in compliance with EN733 - DIN24255 standards coupled to IEC standard electric motors through rigid coupling.

Flow: 120,000 m³/h
Head: 180 m
Power: 7,350 kW

... 600 ft TDH (180 m) 32" to 156" Discharge (813 to 3962 mm) Semi-Enclosed Impeller Models WCAX, YDD, WCA, WCF and WCB​ Enclosed Impeller Models WMCC and WMCE​ PROVEN PERFORMANCE WITH OVER 130 YEARS OF EXPERIENCE: EACH ...

Flow: 0 l/min - 322 l/min
Head: 0 m - 15 m
Power: 3.5 ch

Our diaphragm pumps have proven themselves over decades with dependable performance and minimal maintenance. Ideal for muddy water, high solid content. Handles 1 5/8” solids. For fluids up to 180° F. ...

Flow: 0 us gal/min - 5 us gal/min
Length: 191 mm
Width: 139 mm

... internally and externally Horizontal Suction and Vertical Discharge center porting with Optional Horizontal Side ports An integrated muffler, making it one of the quietest and most compact pumps ...

Flow: 0 m³/h - 44 m³/h
Head: 0 m - 24 m
Power: 1.5 kW - 4 kW

The GR series of belt driven flexible impeller pump is designed for handling extremely viscous fluids up to 50000cp. The belt drive allows the pump to be ran at speeds down to 235RPM, running the pump ...

Flow: 2,600 m³/h
Pressure: 10, 15 MPa
Head: 300 m

... radially split volute, horizontal, centerline mounted. Axial suction, radial discharge, suction and discharge flange pressure rating is the same. The axial force in the pump is balanced ...

Flow: 72 l/h - 2,200 l/h
Pressure: 0 bar - 8 bar
Fluid temperature: 85 °C - 130 °C

... and flexible handling by means of lifting bows. Discharge pumps for Fluidbag and barrels A specialty of ipp Pump Products GmbH is the progressive cavity pump FLB, ...

Flow: 27.5 m³/h - 279 m³/h
Pressure: 0.435 MPa - 0.8 MPa
Head: 0 m - 80 m

ASP1060 type filter press is special feed pump, sanlian pump industry group co., LTD in forty years pump product development and manufacturing experience and strong technical strength ...

Flow: 0 l/min - 100 l/min
Head: 6 m
Power: 150, 300 W

Dewatering Pumps PXJ-150 ●For residual water up to 3mm water level ●Easy to place in narrow space such as sumps or wells with slim body ●Three kinds of connection dia, 1″, 3/4″ and 1/2″, are available with one delivery flange