Electromagnetic contactors

Primary current: 4 A
Load voltage: 250 V

... 4A/250V AC Retrofi ttable to the left of all impulse switches S12 and XS12 as well as switching relays and installation contactors R12 and XR12. ½ module = 9mm wide, 55mm deep.

Primary current: 6 A - 63 A
Load voltage: 24, 48, 110, 230 V

The GYHC series modular contactor uses a new technology platform and applies automated production and testing equipment to create advanced ultra-quiet and long–life contactors. GYHC contactor ...

Primary current: 20 A - 50 A
Load voltage: 0 V - 3,600 V

The contactors type HS for both direct (DC) and alternating current (AC) can be used as polarity-independent circuit breakers in electric traction vehicles. They are used primarily as heating contactors, ...

Primary current: 160, 250, 400, 630 A
Load voltage: 7.2, 12 kV

... series contactor consists of electrical insulating frame, metal base, shaft and crank arm, electromagnetic systems, permanent magnet, power modules, auxiliary switches and vacuum interrupters. While control ...

... this new series of contactors can be produced everywhere among Telema group facilities all over the world, according to specific localisation requirements of every project. Can be used for both AC and DC current (self-supplied ...

Primary current: 16 A - 32 A
Load voltage: 660 V

... machine- interlocking device etc, it becomes the delay contactor, mechanical interlocking contactor, star-delta starter. With the thermal relay, it is combined into the electromagnetic ...

Primary current: 20 A
Load voltage: 12 V - 240 V

Number of contacts: 2x20 A Confi guration of switching and breaking contacts: 20. 11, 02 For switching of electric circuits, especially for resistave loads and three-phase induction motors number of contacts VS120: 1 number of contacts ...

The type K3-K are low voltage contactors that are specifically designed to convert low-inductive and low loss capacitors in capacitors banks that may or may not be equipped with reactors. These contactors ...

HN1710NWE - CONTACTOR 17 A 1NO 380-400 V / 7,5 KW (10.5 HP)

... is infrequently switched. These contactors are primarily for use with Direct Current loads, however they can also be used with Alternating Currents. Coil voltages ranging from 6 to 240 are available for this contactor. The ...

4pole contactors GH16 series for resistive loads AC‐1 utilization category.

Primary current: 9 A - 330 A
Load voltage: 380, 660, 1,000 V

Application CJX2 series AC contactors are suitable for frequency 50/60Hz,rated insulation voltage up to 10000V, rated operation current 9~330A under AC-3 duty.lt is mainly used for making/breaking electric circuits ata ...

Primary current: 0 A - 95 A
Load voltage: 0 V - 690 V

... into electromagnetic starter to protect the circuit’s over-load of operation. Contactor can also be equipped with the building block type auxiliary contacts group, air delay contact, mechanical interlock ...