Encapsulated transformers

... fields are very small in comparison with conventional transformers because of the optimum winding construction. This can result in a reduction in size and weight of up to 50%. GETRA toroidal transformers ...

Primary voltage: 110, 20 kV

Audio-frequency remote control systems are reliable and proven solutions for the remote control of devices in supply networks. We can supply coupling units for the serial and parallel supply of audio-frequency remote control systems in ...

Electric power: 0.005 kVA - 0.1 kVA
Primary voltage: 24 kV - 36 kV
Secondary voltage: 100 V - 120 V

12-24-36 kV Single Pole Insulated Block Type Design Standard: IEC 60044-2, VDE 0414, ANSI, GOST

Primary voltage: 0 kV - 0.7 kV
Secondary voltage: 0 kV - 0.7 kV
Primary current: 50 A - 6,000 A

Cable/Bus-bar type current transformer with DIN-rail/busbar and panel mounting facility. Rated primary currents from 50 A to 6000A(depends on the model). Secondary current is availabe in 5A or 1A. The accuracy of the ...

Electric power: 0 kVA
Primary voltage: 0 V
Secondary voltage: 0 V

Electric power: 0.01 kVA
Secondary voltage: 4, 8, 12 V

10VA transformer for continuous service, outputs 4-8-12V 2 DIN Power supply 230V a.c. – 50Hz Outputs 4-8-12V Installation on terminal board IP20 Wall-mounted IP30 Installation on the rear of the switchboard IP40 Dimensions ...

Electric power: 40 W
Primary voltage: 12 V - 250 V
Primary current: 1 A

Non-Contact Current Transformer Enhance your Smart Grid A non-contact current transformer measures three-phase current at line voltages to protect power systems and to provide critical real-time information ...

Output power kVA: 630 kVA - 31,500 kVA
Primary voltage: 35 kV
Frequency: 60, 50 Hz

SummarThe 35kV transformer, the use of company-specific calculation and verification procedures, the transformer core, coils, active part, leading tanks and other components for a full range of optimized ...

Secondary voltage: 1, 5 V
Primary current: 1, 5 A

... outdoor waterproof current transformers are applicable for AC power system 35kV and measurement of current of power supply equipment below 10KV also can be used for microcomputer protection. This type of current transformer ...

Primary current: 5 A

Model :CMCT102 Rated Input Current :5A Rated Output Current :2.5mA Turns Ratio :2000:1 Phase Angle Error :≤20＇（Input 1A，sampling resistor 100Ω） Linear Range :0~20A（sampling resistor 100Ω） Mounting :Ø5.0mm

Primary current: 160 A

Characteristics:Hand hold type, leading wire output, audio plug connector(or customized), transient voltage suppressor built in. Application: used for the current measuring, monitoring and protecting of AC motor, lighting equipment ...

This linear current transformer series, allow to obtain an AC or DC voltage on output without other transducer. This solution reduce the cost and space of the installation. Mechanical dimension and primary current ...

Primary voltage: 230 V
Secondary voltage: 4 V - 12 V

Bell transformer ZTR-15-12Designated for general use – e.g. as home bells supply, door locks supplyDESCRIPTION Short-circuit-proof, doubled output terminalsTECHNICAL PARAMETERS Input voltage: AC 230 V Output ...

Primary voltage: 230 V

Execution in accordance to VDE 0570 / EN 61558 Prepared for units to protective class II Protective type IP 00 Thermal class E Nominal ambient temperature ta 40°C Input voltage: 230V Output voltage: up to 42V Frequency: 50/60Hz Impregnation Test ...

Output power kVA: 0.025 kVA - 5 kVA
Primary voltage: 100 V - 600 V
Secondary voltage: 12 V - 600 V

... additional accredited bodies. Our transformers offer good access to the four-hole fixing, touch-proof terminals and full varnish impregnation to protect against humidity. • Control Transformer : ...

Electric power: 0.005 kVA - 0.03 kVA
Primary voltage: 5 V - 3,200 V

The LV current transformer series manufactured by ENTES, is a set of models that are specially made to transform primary currents by a ratio to its secondary side with 0 degree phase difference. The network's HV side ...

SES Current Transformers (CT) are used to ensure that electrical systems do not overload and for monitoring large loads by the using a metering instrument. Selection of accurate and reliable CTs are very crucial. It has ...

Transformers of models EI and EE are applied in a wide range and offer ahigh working frequency and wide range of working voltages plus strong output power and good ability in thermal stability。They have been widely used ...

Primary current: 15, 20, 5, 10 A
Secondary current: 2 mA - 20 mA
Frequency: 50, 60 Hz

CURRENT TRANSFORMERS FOR ELECTRONIC ENERGY METERS FEATURES: -Adopted high permeability core, high accuracy, excellent linear performance; -Anti-combustion plastics case; -Encapsulated with epoxy resin ...

Electric power: 0.144, 0.096, 0.06, 0.12 kVA
Secondary voltage: 1.2, 0.8, 0.5 V
Primary current: 120, 0.6 A

... high allowable load impedance and high accuracy enable the CTS transformer to be rigidly integrated with a meter testing system. Once integrated, it can handle both self-contained and transformer connected ...

Primary voltage: 1,200, 720 V
Primary current: 40 A - 7,500 A
Secondary current: 1, 5 A

... current transformer range, these measuring transformers convert high current into lower nominal current value, thus making it possible to use instruments and relays with standardised values of rated current. Part ...

Primary current: 60 A - 630 A
Secondary current: 5, 1 A
Frequency: 50 Hz - 60 Hz

3-in-1 Solid Type CE/ROHS Approved Electrical Specifications • Insulation Voltage : 720V AC • Measurement Range : 20%In~120%In • Accuracy : Class 0.5/Class 1 • Dielectric Strength : 3.0kV/1mA/1min Mechanical Specifications • ...

Electric power: 0.04 W - 5 W
Primary voltage: 230, 400 V
Secondary voltage: 24 V - 230 V

... isolating / isolation transformers, which are protected against direct contact. Products in the LH-series are designed with maximum versatility in every transformer’s functions and technical features. ...

Output power kVA: 0.03 kVA - 2.5 kVA
Primary voltage: 230 V - 400 V
Secondary voltage: 24 V - 230 V

... SINGLE PHASE ISOLATING TRANSFORMERS IP00 Modern and economical make of general purpose isolating and/or safety transformers for building into installations and industrial or power engineering devices. ...

Electric power: 7.5 kVA - 440 kVA
Primary voltage: 460 V - 575 V
Secondary voltage: 133 V - 460 V

... SCR (Silicon Control Rectifier) variable speed motor drive applications, a transformer is needed to magnetically isolate the incoming line from the motor drive. The transformer must also provide a voltage ...