- Hydraulics - Pneumatics >
- Valve >
- IP65 solenoid valve
IP65 solenoid valves
DN: 0.8 mm - 4 mm
Voltage: 12 V - 48 V
Pressure: -1 bar - 12 bar
General purpose high flow proportional valve. Orifice up to 4 mm. Versatile seal (NBR, FPM, EPDM, PTFE, etc...) and body material (stainless steel, brass, Aluminum or plastic) available to adjust to the gas or liquid.
gevasol
DN: 1.2 mm - 4 mm
Voltage: 12 V - 24 V
Temperature: 0 °C - 50 °C
General purpose, media separated solenoid valve for water, aggressive fluids, and gases. Especially recommended with concentrated chemicals such as fertilizer, acids, bases. Valve body ...
gevasol
DN: 0.8 mm - 4 mm
Voltage: 12 V - 24 V
Temperature: 0 °C - 50 °C
... wide versatile general purpose media separated solenoid valve for water, aggressive fluids, and gases. Especially recommended with concentrated liquid chemicals such as fertilizer, acids, bases. Valve ...
gevasol
Voltage: 10 V - 30 V
Temperature: -20 °C - 70 °C
... proportional valves. The unit supplies a variable current proportionally to the reference signal and independently of temperature variations or load impedance, with a resolution of 1% on 2600 mA (the full scale value). The ...
Temperature: 60 °C
Pressure: 25 bar
... type The Delta type EV electrical solenoid valve is a normally closed one-way direct acting valve. It is designed for use as an interrupter valve or as a shut-off valve. ...
Voltage: 12 V - 230 V
Pressure: 0 psi - 120 psi
... Technology manufacturers the SV series solenoid valves offering a complete range of options designed according to NAMUR VDI/VDE 3845, as well as non-NAMUR style valves. For NAMUR style ...
DN: 15 mm - 300 mm
Voltage: 380, 220, 110, 24 V
Temperature: -25 °C - 185 °C
• Connection Type Screw BSP/NPT/DIN/RC Flange DIN, GB, ANSI, JIS • Regulation accuracy: 5% • Explosion class: Non-explosion-proof ,Flameproof Exd II BT4
DN: 2.95, 3.18 mm
Voltage: 24, 5, 12 V
Temperature: 5 °C - 55 °C
... proportional valve providing high flow and high pressure configurations, at less than 2.2 watts of power. This family consists of two orifice sizes and three voltage options. The Parker VSO® MAX HP series is a miniature ...
Parker Precision fluidics Division
DN: 0.3 mm - 8 mm
Voltage: 24 V - 230 V
Temperature: -10 °C - 190 °C
... Controlled by Normally Closed G 1/4" Solenoid Valves are used in a wide variety of applications with or without pressure differential. Ideally suited for air, liquids and gases, these valves ...
Parker Fluid and climate Controls Europe
DN: 0.25, 0.125, 0.375, 0.5, 0.75 in
Voltage: 24, 120 V
Temperature: -15 °C - 49 °C
he H Series ISO Valve is a family of base mounted valves available in five size ranges (Sizes 02, 01, 1, 2 and 3) with flow from 0.55 to 6 Cv. for right sizing the application. The product family has ...
DN: 0.25 in
Voltage: 14 V - 24 V
Temperature: -45 °C - 80 °C
Special features • - Solenoid valve • - High level of operational reliability due to the solenoid with armature and booster valve with ball/seat • - Attachment ...
SAMSON
DN: 5 mm
Voltage: 4 V - 7 V
Temperature: 5 °C - 70 °C
... and tests by the customer. The design of a separate valve seat by the customer is not to apply, as otherwise is needed, if a pilot valve will solely be used. The rate of flow of the cartridge valve ...
A. u. K. Müller
DN: 0.063 in
Voltage: 12 V - 240 V
Temperature: -10 °C - 50 °C
The VDW size 1 is available with resin, brass or stainless steel body with orifice size up to 1/16 inch. Resin body is offered with one touch fitting to reduce installation time. Maximum Cv is 0.07. •Normally Closed type, class B coil •Power ...
SMC Corporation of America
DN: 0.25 in - 1 in
Temperature: -10 °C - 90 °C
... seal material: NBR Seal and diaphragm material: NBR Coil power: AC 10VA (holding) AC 16VA (inrush) DC 7W Protection class: IP 65 (with connector)
M & M INTERNATIONAL
DN: 10 mm
Voltage: 6 V - 24 V
Temperature: -5 °C - 50 °C
The direct acting solenoid valves series "DM" are produced in the 3/2 N.C. pneumatic function with the interface to ISO 1 521 8 and in the 3/2 N.O. - 3/2 N.C. pneumatic functions with not standardized ...
Waircom
Voltage: 24, 220 V
Temperature: 0 °C - 150 °C
Pressure: 0 bar - 8 bar
DN: 1.5 mm - 4.5 mm
Voltage: 12 V - 380 V
Temperature: -10 °C - 140 °C
Armature tube Brass Plunger and core AISI 430FR Springs AISI 302 Seal material NBR - FPM - EPDM FEATURES Maximum allowable pressure PS 50bar Maximum fluid viscosity 25cSt (mm2/s) Ambient temperature: from -10°C to +80°C according ...
ACL S.r.l.
Voltage: 5, 6 V
Temperature: 1 °C - 70 °C
Pressure: 20,000, 800,000 Pa
XHnotion develops new latching solenoid valve for water, which is called bi-stable solenoid valve. The valve will keep original state without power. ...
XHnotion
Voltage: 24, 220 V
Temperature: 5 °C - 50 °C
Pressure: 150,000 Pa - 800,000 Pa
... : 4.5.5VA DC: 3W •INSULATION CLASS: CLASS F. IP65 •TERMINAL: AIR CABLE OR DIN 43650B PIN •FREQUENCY: 5 CYCLES / s •ANSWER TIME: 0.05s LOW ENERGY CONSUMPTION, ESCAPES IN THE PILOT AND THE MAIN ...
DN: 0.8 mm - 2 mm
Voltage: 12 V - 230 V
Temperature: -10 °C - 80 °C
... rangeFluid :-10ºC to 80ºC (no freezing) Ambient : -10ºC to 50ºC Materials in contact with media Main Valve: Aluminium, Stainless Steel AISI 316, Brass Solenoid Operator Stainless Steel AISI 300 & 400 ...
BACCARA AUTOMATION
Voltage: 12 V - 230 V
Temperature: -20 °C - 60 °C
SOLENOID VALVE - EV 3/2-5/2 MONOSTABLE - NAMUR TYPE Solenoid valves : - Namur type with manual switch - IP 65 - Can be installed ...
TUNING Fluid Solutions SARL
DN: 0.75 in
Voltage: 24, 12 V
Temperature: -54 °C - 204 °C
A solenoid operated, 2-way, normally closed, poppet-type, screw-in cartridge valve, designed for low leakage in load holding or blocking applications. Operation When de-energized, the SV08-Z0 acts ...
Hydrabase
Voltage: 230, 24 V
Temperature: -15 °C - 50 °C
Pressure: 1 bar - 10 bar
• For electrical control using PLC control or our singold impulser • Available for different voltages • Direct flow • With manual override • Easily interchangeable magnet system • Service-friendly and maintenance-free
DN: 13 mm - 40 mm
Voltage: 24 V - 230 V
Temperature: -10 °C - 80 °C
DN: 0.25 in - 2 in
Voltage: 24, 42, 110, 230 V
Temperature: -10 °C - 200 °C
... /C and pressure from 5 to 150 psi (0.3 to 10 bar) - Manual Override - Degreased Version - EEx Solenoid- Latching Coil ndumart Series SVP500 Solenoid Valves are suitable for processes ...
DN: 4 mm - 10 mm
Voltage: 10 V - 230 V
Temperature: -30 °C - 80 °C
Control valves for block assembly Nominal sizes from 4 to 10 (CETOP 2 to 5) Operating pressure up to 350 bar Flow rate 140 l/min
DN: 1 mm - 50 mm
Voltage: 220, 230, 240 V
Temperature: -10 °C - 130 °C
... Protection class: IP 65 (with connector and gasket) OPTIONS Available with body thread connection 1/8" (e.g. code RD262DVA). performance ratings remain the same as RD263DVA. Forsteam version with ...
Your suggestions for improvement:
Receive updates on this section every two weeks.
Please refer to our Privacy Policy for details on how DirectIndustry processes your personal data.
- Brand list
- Manufacturer account
- Buyer account
- Our services
- Newsletter subscription
- About VirtualExpo Group
Please specify:
Help us improve:
remaining