- Detection - Measurement >
- Flow, Pressure and Level Measurements >
- Liquid level transmitter
Liquid level transmitters
Process temperature: -30 °C - 60 °C
... of computed readings. Ideal or measurement and control in level and volume applications -Measurement of level, distance, volume, difference and flow -Alarm output in case of flooded ...
Level range: 150 mm - 4,000 mm
Process pressure: 40 bar - 100 bar
Process temperature: -60 °C - 280 °C
Series NI 1341 / 1342 Linear measuring range 150 - 4000 mm Wear-resistant, inductive tracing (differential transformator) powered loop 4 – 20 mA trend display per 10% steps No connection between displacer and electronic
Level range: 15 cm - 3,000 cm
Process pressure: 6,250, 1,000, 3,000 psi
Process temperature: -196 °C - 200 °C
... performance transmitter is a loop-powered, 24 VDC level transmitter that is based upon the proven technology of guided wave radar (GWR). Encompassing a number of significant engineering ...
Magnetrol - AMETEK
Level range: 0.2 m - 30 m
Process pressure: -1 bar - 70 bar
Process temperature: -45 °C - 176 °C
The Pulsar® Model R80 radar transmitter is the latest generation of Magnetrol® 24 VDC, loop-powered, non-contact radar transmitters. Utilizing Frequency Modulated Continuous Wave (FMCW) radar technology, ...
Magnetrol - AMETEK
Level range: 0 mm - 12 mm
Process pressure: -1 bar - 13.8 bar
Process temperature: -40 °C - 93 °C
... been too expensive to use as a replacement for ultrasonic transmitters in simple, daily applications...until now. The R82 radar transmitter can be considered the answer to almost every daily level ...
Magnetrol - AMETEK
Process pressure: 1 bar - 10 bar
Miniature level transmitter (diam. 10mm) output mV/V or 4/20mA 0 ... 10 mCE to 0 ... 100 mCE • Small size, external diameter of the probe : 10 mm • The probe is directly immersed in the fluid ...
Level range: 0 m - 4 m
Process pressure: -1 bar - 10 bar
Process temperature: -20 °C - 100 °C
The NGR is a level sensor that uses TDR technology (time domain reflectometry) and thus can be used in oil- and waterbased liquids without calibration. The NGR’s guided radar uses time-offlight technology ...
KOBOLD Messring GmbH
Level range: 0.5 m - 200 m
Process pressure: 0 bar - 20 bar
Process temperature: -10 °C - 70 °C
... -S Hydrostatic level transmitter Ceramic membrane Seals in FKM viton Direct output of 5 m PUR cable Power supply 10-30 Vdc Issue 4.20 But HART two-wire technique Probe totally in PP or PVDF Special for ...
ASIT ITALIA
Level range: 1 m - 200 m
Process pressure: 100 mbar - 20,000 mbar
Process temperature: -10 °C - 80 °C
Hydrostatic level transmitter Range: from 1 to 200mH2O Overpressure: 1.5 times FS Accuracy: 0.5% FS Temperature -10 / + 80 ° C Compensated in the Range: 0 + 50 ° C Power supply: 11 ~ 28VDC Output: ...
ASIT ITALIA
Suitable for water level measurement, waste water, well water Power supply: 12...36 VDC Output: 4-20mA + HART, 2-wire technique Accuracy: 0.25% 5 m of PUR cable for 0-5m H20 model, 10 m of PUR cable ...
ASIT ITALIA
Level range: 0.2 m - 10 m
Process pressure: -1 bar - 3 bar
Process temperature: -40 °C - 85 °C
... 80GHz mmWave radar level sensor. Its advanced radar technology and user-friendly PC interface ensure precise measurements, high sensitivity, and seamless integration. This non-contact sensor offers contamination-free, ...
Holykell
Level range: 0 m - 80 m
Process pressure: 0 bar - 2 bar
Process temperature: -40 °C - 80 °C
This submersible level sensor adopts SUS304 stainless steel housing and a filter cap(two kinds of filter caps optional), and can be put in water/oil/fuel/chemical tanks or reservoir directly for liquid ...
Holykell
Level range: 0 m - 200 m
Process pressure: 0 bar - 50 bar
Process temperature: -40 °C - 80 °C
... submersible sludge level transmitter is specially used to measure the sludge level in river or lake water.It adopts ceramic filter design, which can filter gravel and water ...
Holykell
Level range: 0 m - 200 m
Process pressure: 0.1 bar
Process temperature: -10 °C - 85 °C
The RIL100 Hydrostatic Level Transmitter is a compact measuring device containing the electronic devices in the stainless steel probe. For continuous measurement of the level of non-aggressive ...
Riels Instruments
Level range: 0 m - 10 m
Process pressure: 0.1 bar
Process temperature: -20 °C - 70 °C
Specifically designed for wide use in the field of dirty water and waste water lifting stations. The RIL160 Level Transmitter uses proven piezoresistive measurement ...
Riels Instruments
Level range: 0.2 m - 12 m
Process pressure: 0.1 MPa
Process temperature: -40 °C - 85 °C
... Properties of the fluid - Viscous / Sticky, Presence of suspended solids REGISTRY FEATURES Displayable units of measure - % of level, Meter Display - Yes Display version - Separate version - wall ...
Riels Instruments
Level range: 0 m - 20 m
Process pressure: 0 bar - 40 bar
Process temperature: -30 °C - 200 °C
... Applications - Distance, level and volume measurement of liquids, powders, granules, with er > 1.5 relative dielectric constant - Chemical industry - Food and beverage - Power plants - ...
NIVELCO Process Control Co.
Level range: 0 m - 200 m
Process temperature: -20 °C - 85 °C
... Suitable for liquid level measurement and control in the fields of petroleum, chemical engineering, power plants, urban water supply, and hydrological exploration. Application Static ...
Process temperature: -30 °C - 150 °C
... capacitive instrument, rod probe suitable for general or chemical-pharmaceutical applications for level measurement of conductive, non-conductive liquids or granules. Installation on the top of metal ...
SGM LEKTRA
capacitive instruments, rope probe for measuring of liquid levels, installation on top of metal tanks Additional information Electrical connection - Terminals Electrodes - insulated PTFE ...
SGM LEKTRA
Level range: 3 m - 30 m
Process pressure: -1 bar - 40 bar
Process temperature: -30 °C - 150 °C
... micro-wave sensor for liquids and bulk solids materials continuous measurement. Insensitive to environmental influences like dust and steam, RWL51 provides accurate and repetitive measurement values. RWL51 constitutes ...
SGM LEKTRA
Process pressure: 0 bar - 10 bar
Features : Suitable for water level measurement. Submersible type. Cost effective. Sensor type : Piezoresistive diaphragm Measuring range : 0 ... 10 bar Output : 4 ... 20 mA Accuracy : ±0.5% F.S. IP rating : IP68
Smart level transmitter type APC-2000ALW/L - Programmable zero shift, range and damping ratio - 4...20 mA output signal + HART protocol - Accuracy 0,16% - Local display - Intrinsic safety certificate ...
Process pressure: 0 bar - 10 bar
• Hydrostatic level measurement • Outside diameter: 23 mm. • Measuring sensor: ceramic • Cable with steel port and compensation tube Description This series of submersible pressure transmitters, ...
Process pressure: 0 bar - 10 bar
• Hydrostatic level measurement • Outside diameter: 40 mm. • Measuring sensor: ceramic • Polypropylene body material Cable with steel port and compensation tube Description This series of submersible pressure ...
Process temperature: 0 °C - 125 °C
EGLStx Level sensors are used for tank level and control. When the magnetic field of the magnet inside the float which moves along the tube according to the liquid level, ...
Process pressure: -1 bar - 100 bar
Process temperature: -40 °C - 400 °C
EGCAP level transmitters are capacitive level sensors used for level measurement in conductive liquids, low conductivity liquids, solid ...
Level range: 5, 10, 15, 20 m
Process pressure: 3 bar
Process temperature: -20 °C - 80 °C
4-20mA, Optically Isolated (2kv) 14bit Rs485 Communication, 2x 8A Relay Output 24Vdc +- 30% / 2W Max. 0.25-0.5 Sensitivity 0.1% Resolution, 3mm 5 - 10 - 15 - 20 Meters Measurement Digital Display
Level range: 0 m - 200 m
Process temperature: -20 °C - 85 °C
... , model LV36 liquid level transducer and transmitter is designed to be submerged in dilute liquid for level measurement. The working principle of LV36 ...
BCM SENSOR TECHNOLOGIES bv
... Submersible Level transmitter Type WTL01 WTL01 level transmitter is a standard and most economic transmitter applied in liquid ...
Celmi
Process pressure: 0 psi - 1,000 psi
Process temperature: -30 °C - 80 °C
... wetted parts CE compliant to suppress RFI, EMI and ESD Ideal for applications including irrigation, tank monitoring, water & wastewater and well head measurement Output signals - 4 mA to 20 mA, 2-wire; 0 Vdc ...
Level range: 60 mm - 3,000 mm
Process pressure: 0 bar - 12 bar
Process temperature: -40 °C - 135 °C
... independent alarm outputs. This level transmitter is very useful in applications where ultrasonic or capacitive transmitters would not work because of the foam, dense vapor, or non-homogeneous ...
Level range: 0 m - 200 m
Process temperature: -40 °C - 85 °C
CS-PT400L series is a highly reliable level transmitter and makes accurate measurements of the liquid level for water, diesel and petrol and corrosive liquid. ...
Level range: 0.5 m - 20 m
Process temperature: -20 °C - 50 °C
Ultrasonic level transmitter for general applications. Standard ranges 0.5 m / 2 m / 4 m / 6 m / 10 m and 20 m Output 4-20 mA, 0 to 10 Vdc, RS485 MODBUS Power 230 Vac / 9 to 36 Vdc Environmental protection ...
submersible level transmitter Submersible level transmitter for immersion in non-aggressive fluids. Stainless steel body and ceramic sensor. Together in FKM. Cable ...
Level range: 610 mm
Process pressure: 0 bar - 20.68 bar
Process temperature: -40 °F - 230 °F
XM-860 Series Continuous Level Transmitters are a durable, low-cost solution for applications that don't require high-resolution output. Made of brass or stainless steel, this series offers rugged construction, ...
GEMS SENSORS & CONTROLS
Level range: 20 m
Process pressure: 0 bar - 40 bar
Process temperature: -40 °C - 200 °C
... which provides improvement for the set up and operation. The LR250 is a 2-wire, 25 GHz pulse radar level transmitter for continuous monitoring of liquids and slurries in storage and process ...
Siemens Process Instrumentation
Process pressure: 4.3 psi - 4.9 psi
Process temperature: -20 °C - 80 °C
... maintenance-free filter preventing particulate or water droplets from entering the transmitter. Low Power Voltage Models Available! PRODUCT APPLICATIONS Ballast tanks Ground water ...
Level range: 0 m - 1.25 m
Process pressure: 2 bar
Process temperature: -7 °C - 60 °C
The general purpose ultrasonic multi-function level transmitter provides continuous level measurement up to 49.2” (1.25m) with a 4-20 mA analog signal output and four relays, and is configured ...
Flowline
Your suggestions for improvement:
Receive updates on this section every two weeks.
Please refer to our Privacy Policy for details on how DirectIndustry processes your personal data.
- Brand list
- Manufacturer account
- Buyer account
- Our services
- Newsletter subscription
- About VirtualExpo Group
Please specify:
Help us improve:
remaining