Pneumatically-operated valves

DN: 0.5 in - 2 in
Temperature: -10 °C - 180 °C

Media: water, oil, air, aggressive media and steam(1) Media temperature: -10°C … +180°C Ambient temperature: -10°C … +60°C Pilot media: air, inert gases, water Body material: bronze (CC491K EN 1982 : 2000) Bonnet material: ...

DN: 70, 145 mm
Pressure: 400 bar - 2,800 bar
Flow rate: 0 l/min - 650 l/min

Pneumatically Switching Valve PSV The reliable switching valve for a wide range of requirements. Available open or closed without actuating energy. Special features: Switchable under ...

DN: 20 mm - 110 mm
Pressure: 16 bar
Temperature: 10 °C - 60 °C

Industrial Series Ball valve with pneumatic actuator made of anodized aluminum Rack and pinnion drive Fast maneuvering Valve position visualization NAMUR connection ...

DN: 51, 25 mm

Pneumatically open and closes valve for for fuel gas Operation is automatic or semi-automatic Pneumatic control pressure can be air, gas or oil Models for 2 in. or ...

DN: 16 mm - 250 mm

Supports safe use in dangerous atmospheres. Compliant with IEC standards, (KOSHA) Korean Occupational Safety and Health Agency's Explosion Proof Certification and (ITRI) Industrial Technology Research Institute's Explosion Proof Certification.

Pressure: 1 bar - 8 bar
Temperature: -10 °C - 60 °C
Flow rate: 500 l/min

... amplifier valve that changes low pressure signals into pneumatic signals (1 ÷ 8 bar).Valve type "XVF5" is instead a 3/2 N.O. amplifier valve that changes negative pneumatic ...

DN: 10 mm

... CONTAMINATED AIR • UNIQUE MOUNTING The BV10 represents yet another evolution in air valve technology from MAC. The Bullet Valve® utilizes “lifting” solenoid technology. ...

Pressure: 5 bar

Designed for diverting positive or negative pneumatic conveying lines and suitable for handing powders or granules. Applications: Multi-Port Rotary Tube Selector Valve diverts pneumatically ...

DN: 15 mm - 200 mm
Pressure: 16 bar
Temperature: -60 °C - 200 °C

Features •Best control characteristics of a ball valve due to specially designed interior contour •Maximum reliability: one piece ball/stem unit avoids weak spot ball to stem •Universally applicable: many options ...

... diaphragm type, relief valve. The single port is held closed buy the force of the adjustable spring located above the pressure sensing diaphragm. When the force of the pressure sensed under the diaphragm exceeds the force ...

DN: 10 mm - 100 mm
Pressure: 25 bar
Temperature: -10 °C - 80 °C

for water distribution domestic and individual 10 BIS : With 1/4'' plugs on both sides to allow pressure gauge connection Possibility of assembly of compensating spring (except for 4'' size) to obtain settings at 0.5 bar Setting ...

... unused valve leg, and is located between two halves of the metal diverting gate. These valves are available in sizes 2", 3", 4", 5" and 6". They can contain manual, motorized, or air-cylinder actuators. ...

Pressure: 125 psi

Change direction of air-conveyed material The Three-Way Sliding Hose Switch by Dynamic Air Inc. is a smooth, full ported, air operated switch for use in almost any pneumatic ...

DN: 40 mm - 300 mm
Pressure: 16 bar
Temperature: -15 °C - 130 °C

... Heat EPDM Disc material Ductile iron GGG50 coated Connection between flanges Operating system Double acting pneumatic actuator

Pressure: 1.5 bar - 8 bar
Temperature: -10 °C - 75 °C
Flow rate: 300, 110 l/min

Signal processing valves These valves suitable for power or control circuits allow to obtain an output signal provided there are both input signals (AND valve) or one of the two (OR ...

DN: 0.125, 0.25, 0.375, 0.5, 0.75 in
Pressure: 0 bar - 10 bar
Temperature: 0 °C - 60 °C

Quick exhaust valve enabling high purge speeds to be reached (valve technology) directly on the wiring circuit or cylinder supply port.

DN: 1 in - 4 in

... Flush Bottom Tank Valves are used for discharging of material from reactor vessels and tanks. Our Ball type Flush Bottom Tank Valves are available in full bore, reduced bore, manual & ...

PDA Pneumatic Control Valves allow for direct remote control of individual friction modules simultaneously on a brake. Brake friction modules can turned on or off from the PDA to set brakes to run ...

Pressure: 29 bar
Flow rate: 12 ft³/min

Shut off valve for individual control Easy connection to air hose

The VGP slide valves are valves designed for heavy and particularly stressful applications. They are normally installed under hoppers, silos and tanks. Driven by pneumatic actuators, ...

Slide valves are used for complete closure of a pipe in the case of explosion, and therefore they are suitable for protection of production technologies with danger of dust explosion. Suitable for pneumatic ...

DN: 8 mm - 200 mm
Pressure: 100, 16 bar
Temperature: -50 °C - 280 °C

... manufacturing of our 2-piece and 3-piece ball valve allow a vacuum capability of at least 10-3 mbar (0,75 10-3 Torr). PED directive According to Pressure European Directive (PED) 97/23/ CE, all our ball valves ...

DN: 2 in - 12 in
Pressure: 10 bar
Temperature: 0 °C - 90 °C

Knife gate valves are a specific type of gate valve that are typically used in industries for handling tough solids and slurries. Named for their shape, knife gate valves have a sharp, ...

DN: 15 mm - 100 mm
Pressure: 16 bar
Temperature: 0 °C - 60 °C

ball valve, ideal for heavy duty applications, chemical applications and water treatment, can be actuated with standard pneumatic actuators using the dedicated kit. The mounting flange is drilled according ...

DN: 50 mm - 1,000 mm
Pressure: 10 bar

... this valve a perfect choice for demanding applications (transport of very heavy fluids, food industry…). Sizes: DN 50 (2”) to 1000 mm (40”) Working pressure up to 10 bar, depending on size. Actuators: Handwheel, Pneumatic, ...