Primary current: 10 A
... series are low-cost surge and lightning arrestors specially designed for airfield lighting application on runways, taxiways or aprons. They meet all international standards, and are efficient in protection against over ...
Voltage: 12 V
Primary current: 10,000 A
The CCTv12 is constructed to provide the protection of Closed Circuit TV (CCTV) or security cameras. It is equipped with television display scrren, video recording system and security cameras. It is designed in compliance with the CE ...
Voltage: 275 V - 550 V
Primary current: 5,000 A - 100,000 A
Surge Protective Device SPD Application • Number of poles: 1, 2,3, 4; • Electric ratings: 230/400V, AC50/60Hz; • Application: Protect electric system and on-loading electrical apparatus from thunder and instantaneous ...
... electronics component to be protected is not affected. Surge arresters are used to weaken residual currents from upstream lightning protection steps and to limit system-induced ...
Endress+Hauser AG
Voltage: 30 V - 500 V
Primary current: 0 mA - 100 mA
... high-performance AR surge arrester absorbs the potential of an inductive lightning surge caused by a lightning discharge to protect electronic instruments. The plug-in arrester ...
... control systems Pepperl+Fuchs‘ surge protection modules reliably divert surges and currents to ground and protect people and machines against possible negative consequences. Our product range provides ...
Voltage: 0 V - 40 V
... max. Input current must less than FS-A01D’s nominal current. Feature: Compact size Design to suppress the DC power surge to achieve primary protection The attenuation coefficient of frequency meet 30dB ...
Voltage: 2,000 V
Pasternack DC blocks are passive coaxial components that prevent (block) the flow of direct current (DC) frequencies to RF signals. DC blocks from Pasternack are available in 50 Ohm and 75 Ohm designs and can be purchased in inner-only, ...
Pasternack Enterprises, Inc.
Voltage: 240 V - 415 V
Primary current: 100 A
... interrupt rating Ifi - N-PE - 100 A (260 V) Max. discharge surge current Imax (8/20)μs - L-N / N-PE - 40 kA / 40 kA Voltage protection level UP L-N / N-PE - ≤ 1,5 kV / 1,5 kV Nominal discharge surge ...
Voltage: 3, 20 kV
... are connected to the terminal block signal, power and earth terminals. Hazardous Area Certifications The TP series surge protectors are certified to numerous worldwide approval standards for hazardous ...
Lightning protection units are available to help protect your AMETEK Level Transmitters and Measurement Systems from unexpected lightning and secondary surges. These high performance ...
Voltage: 10 V - 32 V
... Weighbridges The LC30 Surge Protection Device protects weighing systems and load cell installations from possible malfunction and damage caused by severe over-voltages or high impulse currents on signal cabling. Potentially ...
CeraDiodes are multilayer semiconductive ceramic components for the ESD protection of data, audio and video lines, ICs and I/O ports in electronic devices. New series are designed especially for the ESD protection of LED light sources. ...
TDK Electronics Europe
... Ethernet (PoE) surge protectors are ideally suited for protecting network devices that may be susceptible to damage from surge or voltage transient events in space restricted installation ...
... industrial Power over Ethernet (PoE) surge protectors are ideally suited for protecting network devices that may be susceptible to damage from surge or voltage transient events. Designed ...
Voltage: 0 V
Primary current: 40, 50 A
1/4λ surge arrestors are used for protecting antenna equipment and transmission-receiver system against the damages caused by over voltage and induction voltage of lightning. The product is designed according ...
Voltage: 0 V - 5 V
Primary current: 5,000 A
... various interferences caused by the common ground transmission signal -The excellent lightning protection performance, built-in multi-level surge protection, large surge ...
3onedata Co.,Ltd.
Voltage: 180 V
Primary current: 10,000 A
... exceptional in-line broadband DC pass surge protection design incorporating lightning protection circuitry and the EZ-195-X series crimp style connector interface unit. This combination ...
Times Microwave Systems
Outdoor In-Line PoE Surge Protector - IP66 Rated, 1 Gbps, Cat5e/6/6a, IEC Compliant, TAA Protects edge network devices, including PoE cameras and LAN access points, from lightning, power surges, ...
TRIPPLITE
Voltage: 150 V - 600 V
Primary current: 100,000, 200,000 A
Class I+II Rated voltage up to 600 Vac Application from 1 to 4 poles Visual and remote contact indicator Benefits Easy installation DIN rail mounting Max nominal discharge phase 100 kA, neutral 200 ...
ENERDOOR
Open circuit voltage: 8 kV
Protects SDI equipment from high voltage surge such as lightning Protects surge up to 8KV Discharging current up to 10KA Reaction speed <1ns Protects HDMI equipment from high voltage surge ...
Surge Protection Device RJ45-SPD Class EA; suitable for RJ45/11/12 plugs CU-CN Surge Protection Dev RJ45-SPD TH35 Surge Protection Device RJ45-SPD Class EA suitable for RJ45/11/12 ...
Primary current: 20,000 A
... designed this lightning protection to save their pumps and after we installed this product, they never had problems with lightning anymore. Since then, every client who sends us a main board for repair, ...
Voltage: 1 V
Primary current: 2.7 A
Smart Bias-T, 696-2690 MHz, Also known as SBT-6962690-xxx
Please specify:
Help us improve:
remaining