Turbine pumps

Flow: 30 us gal/min - 10,000 us gal/min
Pressure: 80 psi - 290 psi

Vertical Turbine pumps. Flow - 300 USGPM to 10,000 USGPM Head - 80 PSI to 290psi MOC - Cast Iron / Ductile Iron / SS304 or 316 / Super Duplex SS / Ni Aluminum Bronze Primer - Electric and Diesel Engine.

Flow: 50 us gal/min
Head: 700'00"

Single Stage Close Coupled Regenerative Turbine Series 100 Key Features End-Mounted, Close-Coupled Design with Single Mechanical Seal and choice of 3500 RPM or 1750 RPM Very Economical: Speeds Equal Greater Capacity ...

Flow: 6,626 m³/h
Pressure: 105 bar
Head: 1,067 m

... Vertical Turbine Generators are actually reverse running pumps. When the flow that runs through the pump is reversed, the impeller starts turning in the other direction and the pump ...

Flow: 20 m³/h
Pressure: 5 bar

Gear Pump For LB Freezer Overview of Gear pump for LB freezer： LB type refrigeration machine gear pump is used to transport viscosity in 5-1500 cSt all kinds of non-solid particle ...

Pressure: 0 bar - 25 bar

Lubricating oil pumps / Grease pumps Gear pumps or Rotary lobe pumps Steimel lubricating oil pumps are suitable for use in oil supply equipment for ...

Flow: 10 m³/h
Pressure: 16 bar

STM regenerative turbine pumps are ideal for low flow/high head applications. They are able to pump liquids with up to 20% gas content. When the pump's feed is a mixture ...

Flow: 11 m³/h - 11,500 m³/h
Head: 120 m

... space requirements Multistage canned vertical turbine pumps offer the same versatility and performance as our lineshaft pumps and are ideal for closed-loop boosting. These are short-set ...

Flow: 0 m³/h - 4,000 m³/h
Pressure: 0 bar - 20 bar
Head: 0 m - 200 m

The North Ridge Pump as Turbine (PAT) system is an innovation in pump technology. It allows the pump to run in reverse as a turbine to harness any wasted ...

Flow: 1 l/s - 30 l/s
Head: 2 m - 80 m
Power: 1.1 kW - 11 kW

... products range (about 856 among pumps and mixers) includes different models according to a variety of models,from 0,5 kW to 350 kW, 2-4-6-8-10-12 poles (50Hz and 60 Hz). CONSTRUCTION DATA Submersible electric pumps, ...

Flow: 8 l/min - 60 l/min
Pressure: 0.21 bar - 0.5 bar
Power: 10 W - 250 W

FEATURES Centrifugal pump for re-circulating and transferring of liquids. A selection of models with pump rates of 8 to 60 litres/ min. The motor power to the turbine is transmitted ...

Flow: 0.5 m³/h - 240 m³/h
Head: 4 m - 305 m
Power: 0.37 kW - 110 kW

... within minutes .High efficient,energy saving,low noise,environmental friendly,light weighted, easy to use and maintain,with compact WORKING CONDITIONS Ambient temperature: <40 °C Altitude: up to 1000m APPLICATIONS Water ...

Flow: 1.48 m³/min - 3.85 m³/min
Pressure: 9,800 psi - 18,247 psi
Power: 2,250 kW - 3,300 kW

... Jereh self-developed Apollo 4500 turbine-driven frac pumper is powered by the turbine engine. Possessing the world's largest single-unit power, it matches with a 5,600hp turbine engine ...

Flow: 0 l/min - 1,000 l/min
Pressure: 0 Pa - 276,000 Pa
Power: 750 W - 5,000 W

Characteristics Compact structure, easy installation and maintenance, low noise, smooth operation, long service life. Built-in check valve, switching valve, safety valve(relief valve) and vacuum valve. ...

Flow: 68.1 m³/h - 823.3 m³/h
Pressure: 175 psi

Cyclone Vertical Turbine Pumps Cornell Pump’s VT pump series (Cyclone) relies on our demonstrated superior hydraulics, in a submerged design. The proven quality of ...

With our hand-lever pumps you can easily generate a hydraulic pressure up to 2500 bar. The pumps are mainly suitable to operate small devices or during maintenance. Manual ...