Signal amplifier 1073A

distributionfiber opticmulti-channel

Looking for a time code distribution solution? Need even more outputs? Is your installation spread across a wider geographic area? Is a second clock not practical? The Model 1073A was built to address these and other challenges, while providing the flexibility to configure the device to fit specific needs. Designed to buffer and distribute time codes and signals generated by sources such as Arbiter Systems' GNSS Synchronized Clocks, GPS Satellite Controlled Clocks, and GPS Substation Clock. Model 1073A includes three separate channels, each with four high drive outputs. Via copper or the optional fiber optic board, you can link additional facilities easily, and still get the high accuracy without adding more clocks Output capabilities include AC and DC coupled modes. In AC-coupled mode, the unit can receive and distribute timebase and reference frequency signals up to 10 MHz. In DC-coupled mode, Model 1073A can distribute 5 V CMOS/TTL logic-level signals such 1 PPS and unmodulated IRIG-B timecode Ability to extend time signals generated by Arbiter Systems' GNSS Synchronized Clocks (1201B/C, 1202B/C. . .), GPS Satellite Controlled Clocks (1088B, 1093B/C. . .), and GPS Substation Clock (1094B) Copper or fiber-optic cabling input support Time code and frequency signals support (not suitable for distribution of modulated IRIG-B signals) I/O Configuration Channels Three, each with four outputs Mode: Independent Each channel independently driven Common A/B B/C outputs driven by A or B input Selection Internal push-on jumpers Output Connectors 50-ohm BNC, four per channel Fiber Optic Type ST, for 62.5/125 µm multimode fiber, optional (1073opt01)