Signal amplifier AM-OP series
powercurrentvoltage

signal amplifier
signal amplifier
Add to favorites
Compare this product
 

Characteristics

Type
signal, power, voltage, current
Secondary function
switching
Other characteristics
electronic, DC, single-channel, 2-channel, switching frequency, DIN rail, temperature, for sensors, EMC
Voltage

Max.: 260 V

Min.: 24 V

Current

300 mA

Frequency

50 Hz, 60 Hz

Description

OPTOCOUPLED STATIC OUTPUTS • 1 or 2 channels • General Features: These units allow to amplifiy signals from NAMUR sensors or contacts. Each output is electrically insulated from each other, from power supply and from all the inputs. It is possible to configure them as N.O. or N.C. and use them as PNP or NPN. They are protected against over voltages on lines, overload and short circuit. When used for NAMUR sensors, the indication of failures is visible with a red LED on the front panel for interruptions or short circuits on the input lines. The configuration dip-switches are easily accessible removing the front panel. Suitable for DIN rail mounting. Technical data: • Supply voltage: see ordering references • Frequency of power supply: DC or 50 - 60 Hz • Power consumption max: see ordering references • According to EN60947-5-6 • Electromagnetic compatibility (EMC) according to EN61000-6-2/-4 INPUT PARAMETERS • Switching point to ON: 1,55 ÷ 1,75 mA • Switching point hysteresis: 0,2 mA • Failure detection thresholds: open circuit detection when I 7,45 mA (Ri < 100Ω) OUTPUTS • Outpu:t function: N.O. or N.C. as for DIP-SW settings • Polarity: NPN/PNP • Switching frequency max: 900 Hz • Input/output delay max: 700 µs • Output current max: 300 mA • Max applicable voltage through the load: 65 V • Voltage drop max in ON condition: 1,7 V • Insulation from power supply and from inputs: 2500 V

Catalogs

Other BDC ELECTRONIC S.r.l. products

OPTOCOUPLED STATIC OUTPUTS

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.