video corpo

LED UV integrator Typ LED

LED UV integrator - Typ LED - Beltron GmbH
LED UV integrator - Typ LED - Beltron GmbH
Add to favorites
Compare this product
 

Characteristics

Type
LED

Description

General: The Beltron LED UV Integrator is a high-quality measuring device for determining the UV dose. On the back of the device a UV sensor is located, which detects the LED / UV radiation. The LCD display directly reflects the measured value in millijoules per square centimeter (mJ / cm²). The LED UV integrator is powered by a 3.6 volt lithium battery, which is located inside the device. By using particularly energy-saving circuits, the battery lasts for about 10,000 operating hours. A special filter blocks the visible as well as the IR range of the radiation so that only the desired spectral range will be measured. Handling: To take a measurement, proceed as follows: 1.) Activate the LED UV integrator by pressing the toggle switch. An irradiation value (dose) of 0 mJ / cm² is displayed on the LCD-Display. 2.) Turn the LED UV integrator in a position that the sensor faces to the radiation source. Then let the integrator run under the UV source respectively allow it to illuminate for the desired time. 3.) After completion of the exposure, the measuring value is shown on the display e.g. 550 mJ/cm². 4.) After completing the measurement, switch off the device via the toggle switch. When switching on again, the LED UV integrator is reset to "zero" for the next measurement. Please note that the housing temperature must not exceed 110 ° for 10 seconds!

Catalogs

Related Searches
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.