Connection interface 9206

USBhigh-speedcompact

USB multisensor interface - 9206 In the field there is a frequent need to measure sensor readings rapidly and easily right at the sensor and to transfer them directly to a PC without additional amplifiers or converters. The 9206 USB sensor interface can satisfy this requirement admirably, thanks to its „plug & measure“ design. The USB connection means installation could not be simpler. Typical applications: -Mobile test measurements via laptop -Laboratory test set-ups -Instrumentation and control -Diagnostic measurements in the chemical industry -PC-based recording of expansion figures in bio engineering The USB sensor interface takes its supply from the connected PC via the USB port, and uses it to generate the power supply for the sensors. The initial settings and sensor settings are made by burster in-house and saved in the USB sensor interface. These can then be fine-tuned by the customer. Software provides display and archiving functions. But a license key enables an open-end expansion. 32 interfaces output curves may be displayed at the same time. One USB sensor interface can be connected as standard. Each sensor can be tared individually, and measurement curves can be displayed jointly or separately in a graph. We can configure the interface to suit a specific sensor, although customer-specific parameters can be changed using the free analysis software supplied. The connection to LabVIEW or the integration into customers’ software is enabled by a free driver package.