CNC motion controller AXBB-E

6-axisEthernethigh-speed

The AXBB-E is a CNC Motion Controller and breakout board combination with Ethernet interface. The device can communicate with a connection to the control computer’s network card. The connection can be built with direct connection or via router/switch devices in a local area network (LAN). This makes it an excellent pairing with the UCCNC motion control software. The device can be used to control machine tools with stepper or servo motor controls with step and direction interfaces. There are 8 isolated outputs to drive relays, solid state relays, laser controller or anything else which require isolation. There are 6 isolated inputs to input signals of sensors, switches and push-buttons. There is one safety charge pump circuit with isolated output. The controller can output a maximum of 400kHz stepping frequency and can work with up to 6-axes, however only 8 dedicated step and direction signal pins for 4 axes are wired out on the board, but the I/Os on the software side are freely configurable to any pins making it possible to use all 6 axes if required. In addition to the breakout signals there is one IDC26 port on the board which has standard LPT port pinout. An IDC26 to DSUB25 cable (not included) can be used to connect an additional standard LPT port compatible breakout board to the device to extend the number of I/Os if required. The board also has 2 analog input channels which can work with externally connected potentiometers (not included). The recommended potentiometer full scale resistance is 1k to 10k Ohms. The analog input channels can be used to control the feed rate override and the spindle speed override in the software.