Lubricated vacuum system XV-0300-01-06-10

Rotary-claw type pumps are ideally suited to large scale VRTM processes, combining exceptional toughness, high-flow rates and low output noise. This type of vacuum system is not adversely affected by air-admittance during the moulding process (‘rough’ vacuum), unlike oil-lubricated pumps which despite achieving higher levels of vacuum, will vent oil vapour if used in this type of application. Available as a stand-alone pump or in a range of configurations. -High output, oil free rotary-claw type 80 m³ vacuum pump -Standard vacuum pump is three phase, 415 V supply with a rated output of 1300 litres/min -Achievable vacuum levels of 40 mbar (absolute) -Highly reliable and relatively quiet -High-flow rate ideally suited for multiple mould operations -Fitted with a replaceable cartridge filter to prevent dust and fibre entering the pump -Long service intervals Simple ON/OFF Control • Start/stop DOL control with motor overload protection Full Switching Control • Digital display of vacuum gauge level • User adjustable digital switching unit to minimise pump operation whilst providing constant vacuum output • Automatically turns pump ON/OFF between pre-set minimum/maximum vacuum level settings • Control unit with MCB fusing, motor overload protection, and solid-state relay power switching Absolute Vacuum Gauge • Digital display to provide readout of vacuum level from atmospheric pressure down to zero mbar (absolute) Hours-Run Meter • Electronic counter to record the total pump use in hours • Allows accurate planning of service intervals Large Reservoir • 200 litre vacuum reservoir • Includes six vacuum take-offs