External-toothed slewing ring 3x series
ball bearingsingle-rowwith square flange

External-toothed slewing ring - 3x series - DEFONTAINE - ROLLIX - ball bearing / single-row / with square flange

Add to favorites

Compare this product

Go to the DEFONTAINE - ROLLIX website for more information

Characteristics

Teeth

external-toothed

Rolling element

ball bearing

Geometry

single-row

Other characteristics

with square flange

Inner diameter

Max.: 1,022 mm
(40.24 in)

Min.: 342 mm
(13.46 in)

Outer diameter

Max.: 1,198 mm
(47.165 in)

Min.: 505 mm
(19.882 in)

Number of teeth

Max.: 148 unit

Min.: 99 unit

Module

5 mm, 6 mm, 8 mm
(0.2 in, 0.24 in, 0.31 in)

Fixation hole diameter

Max.: 1,135 mm
(44.7 in)

Min.: 455 mm
(17.9 in)

Number of fastening holes on the outer ring

Max.: 44 mm
(1.73 in)

Min.: 20 mm
(0.79 in)

Number of fastening holes on the inner ring

Max.: 48 mm
(1.89 in)

Min.: 24 mm
(0.94 in)

Description

Standard light series ball slewing ring sqaure section with external gear with an average raceway diameter from 411 to 1,091 mm These slewing rings are not recommended for hanging loads. Vertical use must be limited due to clearance. These ball slewing bearings are also available without drilled holes, with identical part numbers, but differentiated by the last two characters: • - 00: without fastening holes • - 01: standard drilling Light series slewing rings with square sections have a slightly higher load capacity than the ones with a L-shaped profile. There are 3 different gear run-outs levels for each family (standard, low, very low).