Slewing ring without teeth 3z series
ball bearingsingle-row

Slewing ring without teeth - 3z series - DEFONTAINE - ROLLIX - ball bearing / single-row

Add to favorites

Compare this product

Go to the DEFONTAINE - ROLLIX website for more information

Characteristics

Teeth

without teeth

Rolling element

ball bearing

Geometry

single-row

Inner diameter

Max.: 1,022 mm
(40.24 in)

Min.: 342 mm
(13.46 in)

Outer diameter

Max.: 1,166 mm
(45.906 in)

Min.: 486 mm
(19.134 in)

Fixation hole diameter

Max.: 1,140 mm
(44.9 in)

Min.: 460 mm
(18.1 in)

Number of fastening holes on the outer ring

Max.: 48 mm
(1.89 in)

Min.: 24 mm
(0.94 in)

Number of fastening holes on the inner ring

Max.: 48 mm
(1.89 in)

Min.: 24 mm
(0.94 in)

Description

Standard light series ball slewing ring square section without gear with an average raceway diameter from 411 to 1,091 mm These slewing rings are not recommended for hanging loads. Vertical use must be limited due to clearance. These ball slewing bearings are also available without drilled holes, with identical part numbers, but differentiated by the last two characters: • - 00: without fastening holes • - 01: standard drilling Light series slewing rings with square sections have a slightly higher load capacity than the ones with a L-shaped profile. There are 3 different gear run-outs levels for each family (standard, low, very low).