Sheet metal straightener-feeder B series

Material:Cold rolled sheet, hot rolled sheet, pickled sheet, galvanized sheet, stainless steel sheet, copper, aluminum Material Thickness：0.3 ～ 3.2 mm Note: Please refer to the correction ability table for thickness x width. Material Width：100 ～ 1800 mm Yield Strength ：≤245 N/mm2 Coil Inner Diameter:Φ450~φ530mm/φ480~φ530mm/φ580~φ630mm Coil Outside Diameter:max φ 1600 mm Coil Weight:3000~15000kg Standard accessory: 1.Electric eye loop control system 2.Outgoing catenary to assist and support the material 3.Hold down arms device 4.Feeding line easily adjusts by advance worm gear screw jacks device 5.Leveling setting wheel with meter panel 6.The uncoiler contain the butterfly brakes air compressor 7.Uncoiler-inverter device 8.Feed and staightener rolls with a hard chrome finished Openable Straightening Head the whole part of the upper straightening part is openable,which is convenient for cleaning the surface of the work rollers,such as oil stain,waste scrape,non-ferrous metal oxide layer,etc. Automatically Adjusting Correction Adjust the correction amount by geared motor/servo motor,the memory can store 99 sets of numerical parameters,can be called at anytime. Coil Car It is used to smoothly transfer the coil to the spindle of coil shaft.It is used to lift the stripend so that the sheet can smoothly enter the leveling machine.Coil car is provided with a material roll anti-dumping baffle.It can effectively prevent the roll from falling over when the metal coil is narrow.