EtherCAT I/O module TRIO P series

digitalanalogEthernet

The Flexslice system starts with the coupler. The coupler can be connected to the EtherCAT network through the Ethernet port above the module. The RJ45 interface below the module can be used to connect more EtherCAT modules on the same line. The PB66 bus coupler supports up to 16 I/O modules. These modules have flexible mechanical locks and bus interfaces, which can be connected to EBUS through the backplane. PB66 is installed with guide rail. It can convert the message from Ethernet 100BASE-T to EBUS signal format. In the EtherCAT network, the P366 coupler can be installed anywhere in the Ethernet network, making it suitable for opération near the master station or remote location. PRODUCT PARAMETERS: Required power supply 24V DC, the minimum requirement of the whole system is 0.8A EtherCAT interface RJ45 agreement EtherCAT Data rate 100 Mbit/s Power supply 24V/1.5W Insulation 1KV EtherCAT update cycle 2: 125us Network cable CATSe FEATURES: I The P371 digital output module connects the binary control signal of the motion controller and the 24V DC output device of the machine. I Ail 16 outputs are current source (PNP) with electrical insulation. I Output and power connections are made through two single row plug-in screw terminais. I The Flexslice module displays the status of the output signal through LED lights. I P372 digital input module connects 24V DC signal from machine equipment to binary control register in motion controller. I Ail 16 inputs are current absorption (PNP) and electrically insulated. I Input and power connections are made through two single row plug-in screw terminais.