Pillow bearing unit ZDS2SN
steelrubberwith setscrew locking

Pillow bearing unit - ZDS2SN - FYH - steel / rubber / with setscrew locking
Pillow bearing unit - ZDS2SN - FYH - steel / rubber / with setscrew locking
Pillow bearing unit - ZDS2SN - FYH - steel / rubber / with setscrew locking - image - 2
Add to favorites
Compare this product
 

Characteristics

Type
pillow
Material
steel, rubber
Other characteristics
with setscrew locking, with cylindrical bore
Inside diameter

Min.: 60 mm
(2.36 in)

Max.: 100 mm
(3.94 in)

Outside diameter

Min.: 125 mm
(4.92 in)

Max.: 187 mm
(7.36 in)

Length

Min.: 280 mm
(11.02 in)

Max.: 410 mm
(16.14 in)

Description

ZDS2SN Cylindrical bore (with Z-Lock (both)) (with set screw collar lock (both)) d 27 /16 ~ 4 inch 60 ~ 100 mm Contamination is the single biggest problem that bearings face in applications such as aggregate, mining, forestry, pulp and paper and steel mills. Split plummer block units have single lip rubber seals that contact and wear on the shafting. FYH’s original triple lip seals contact on the inner ring and can handle ±2 degrees of shaft misalignment, plummer block seals are not designed for this amount of misalignment. Adapter sleeves used in a split plummer blocks require time and skill to install correctly, incorrect installation can allow them to be too tight or too loose. FYH’s true concentric Z Lock can be installed much faster and easier than adaptor sleeve locks. The installation of Z Lock bearings should be able to be completed in less than ten minutes and saves cost in both time and manpower.
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.