Covers for cable and/or utility shafts in tunnel structures, square design
Shaft cover is resistant to surface water, load-bearing, fireproof, impervious to smoke and designed for concreting in to fit flush with the ground
Load class:
B 125 kN/D 400 kN in accordance with EN 124,
90 / 120 minute fire-rated – tested and certified
Materials and construction:
Frame and lid trough in stainless steel V2A-1.4301/ V4A-1.4571
Frame with reinforcement attached externally plus height adjustment, fire-insulated centre strut fitted to multi-section covers, lid pre-assembled to allow reinforcement to be inserted and for subsequent concrete in-fill, lid with frame secured using three-square brass bolts, resistant to surface water, frost and weather-resistant and heat-resistant seal made from silicone foam profile. Design variations: single-section covers and covers with two or more sections with centre struts.
Features
Tested and certified for enhanced fire safety requirements with a 90 / 120-minute rating for fire and smoke and for load class B125kN/D400kN in accordance with EN 124.
Utility cables remain protected in cable shafts even in the most extreme heat to maintain the supply (of electricity, water and so on) via the relevant media.
The Type H-CSC Cable Shaft Cover is designed to fit flush to the ground for concreting in and is supplied with a lid trough also designed for concrete in-fill.
Load classes B125kN/D400kN in accordance with EN 124
Fire-rated – tested and certified – ultra flame-retardant
Construction height 150mm = 90 min. / Construction height 180mm = 120 min
Square design, fits flush to ground for concreting in