Swing clamps, compact design, with lower flange and threaded body (B)
Swing clamp cylinders operate single-acting with reset spring or double-acting hydraulically. The hydraulic oil supply can be connected by G1/8 threaded port or by manifold connection with O-ring. For any risk of exceeding the permitted volume flow a throttle check valve must be interposed into the oil supply line. Counter-hold the clamping arm when tightening or loosening the fixing cap screw in order to prevent torque transfer to the piston rod and to avoid damage to the ball guide.
The clamping procedure is initiated with a superimposed swing and stroke movement. After that, a linear clamping stroke follows. Cylinders with swing angles 0°, 45°, 60°, 90° are available as standard. The clamping force is depending from the length of the clamping arm. Except for the standard clamping arm also special clamping arms can be assembled. The maximum operating pressure of 350 bar only applies to clamping arms with a maximum length of 26 mm.
Special features:
compact design
various mounting options
standard clamping arms with contact bolts are available as accessories
can be equipped with customer specific clamping arms
Designs:
Type B, lower flange
The dimensioned installation contour can be found on the data sheet.
Mounting options:
Accessories:
Clamping arms and contact bolts
are available as a set of accessories.
Single clamping arm L = 26 mm
incl. contact bolt:
Order no.: SPE-126-001
Slotted nut:
Order no.: 4040-086
Operating pressure: pmin. 25 bar - pmax. 350 bar
Operating method: single-acting or double-acting
Swing angle: 0°, 45°, 60° and 90°