Wind speed indicator WM44-SS V3

digitalLEDpanel-mount

Anemometer display with alarms. WM44-SS V3 have a 2-digit wind speed reading in km/h or MPH. Choosing one of the 2 options is possible at any time by pressing “SELECT”. It admit 2 and 3 wire sensors and have a 10-20 Vdc power output. Wind speed display with 2 alarms Pre-configured to work with Anemo4403 V3 pulses output sensor Adjustable pre-alarm and alarm Panel version 36x72 mm Display Wind speed data displayed on a 2-digit 20mm display. 2 alarm enabled indicator LEDs (AL1 and AL2). Wind speed can be displayed in km/h or MPH and can be selected in any moment by pressing "select" button removing the cover. Alarms The alarm is triggered when the wind speed reaches or exceeds the programmed value. It includes a delay to prevent the alarm from being triggered by gusts of winds. The alarm is deactivated when the wind speed drops below the programmed value. It also has a delay to prevent the alarm from being deactivated by temporary periods of low-intensity wind. The activation of ALARM2 deactivates ALARM1. When ALARM2 is activated, the reading will blink to warn about the danger. Alarms configuration: Trigger values, polarity, intermittent or continuous alarm, alarm latching (only ALARM2) Alarms outputs: Relays. Contacts “NO” and “NC” (ALARM1), contact “NO” (ALARM2). Dry contact relay contacts. User Default Setting The setting can be saved as “User Default Setting” and can be retrieved when necessary P00 – (4). If no configuration has been saved, the factory configuration can be reset with this process. Wind Speed Sensors It is recommended to use IED Electronics Anemo4403 V3 Pulses output. 2-wire and 3-wire sensors can be used.