Manual plasma cutter Avalon 100 HF

IGBT invertermobile

Particularly powerful plasma source Capacity up to 45 mm in steel Equipped with torch 8 meter P-80 Affordable wear parts Duty cycle 100% Air consumption 180 l / minute 4 bar Weight only 36 kg Cuts pretty straight and fast Particularly low energy consumption 100 Amp 3 x 400 volts With central connector torche (Binzel) The Avalon 100 plasma cutter, with its capacity of 45 mm, is by far the strongest machine in an capacity of 100 AMP The P-80 HF torch with a length of 6 meters, which comes standard with the Avalon 100 is calculated on the full power of this Plasma cutter. Also note that the wearing parts for this torch are quite affordable. The resulting cut is straight and does not run forward Up to a profile thickness of 40 mm. The limited weight makes this machine very suitable for use outdoors The IGBT power source (Panasonic) limits energy consumption in contrast to plasma cutters with Transformer The ignition is done by means of an HF ignition. This plasma cutter can be used for cutting all Ferro and non-ferrous materials, such as stainless steel, steel, copper, ALU, etc. The required compressed air that is converted into an ionizing plasma gas on the one hand and refrigeration gas on the other hand can simply be supplied by A 3 HP compressor. The compressed air requirement is limited to 250 litres at 4 bar, make sure that you use dried compressed air, without oil particles