Band saw PH 211-1

miterhorizontalfor metals

The PH 211-1, manual band sawing machines for cuts from 0° to 60° on the left are also supplied in a version with HB device to make single cuts without operators, still keeping the manual cutting cycle available ( the HB device is available only in the three-phase version) HB CUTTING CYCLE: After positioning the bar and closing the vice, the cutting phase is started, using the weight of the saw frame controlled by a hydraulic circuit to adjust the downfeed speed; after the cut the band stops, the frame is manually lifted in order to reposition the bar to cut untill the position needed by the operator , at this point the head frame is locked by the manually-controlled hydraulic valve. – Sturdy structures in cast iron in order to tension the band at 700 kg. – Electrical board with entirely identifiable wiring, stand-by, main switch with lock, short circuit protection, motor overload cutout, min. voltage coil, low voltage system 24 V. – Control handle IP55. – Driving pulley locked with clamp ring to ensure a strong fastening, still allowing axial adjustment. – Blade-guide heads with 6 CARBIDE pads instead of bearings to ensure a better stability. – Stop strokes at 0° and 60° on the left with lever for locking at any intermediate angle. – Head articulation with preloaded tapered bearings. – Vice with fast locking lever. – Electric pump for the band lubrication and cooling. – Brush band-cleaning device. – Bimetallic band for profiles and solid pieces. – Instructions manual and spare parts list.