Turbine pump VTC

waterstationaryindustrial

The suction inlet goes down vertically and the spit outlet extends horizontally. According to the form of foundation, the long shaft pump with double foundation structure can be produced; according to the axial thrust, there is not only the structure of the pump bearing the axial thrust, but also the structure of the motor bearing the axial thrust. According to the form of the rotor, the non- extractable structure of the rotor can also be produced at the same time. The impeller can be made into one stage or multi-stage. The high lift long shaft pump has a unique structure invented by ourselves, the secondary impeller rear structure, the différent head combination structure under the same flow rate, and the unique pressure relief structure at the packing body. The standard seal is a packing seal. Draw water from a suction pool or directly from rivers or océans. Pump shaft seal for the vast majority of packing seal structure, at the same time can also use integrated mechanical seal structure, water guide bearings according to user requirements, using a variety of configurations, the standard configuration of polytetrafluoroethylene and rubber guide bearings, sea water is generally configured for Sailong guide bearings, high-end configuration for AR bearings and ceramic bearings. The lubrication of the water guide bearing can be determined according to the water quality, and the good water quality can be directly lubricated by the water of the pump body itself. if there are particles or sand shafts in the water quality, a protective pipe can be set up to connect the clean industrial water lubricated water guide bearing to prolong the service life of the sleeve and bearing.