CCD spectrometer ATP2400

CMOSmeasurementoptical

ATP2400, which has built-in pulsed xenon lamp drive circuits, adopts high sensitivity linear CMOS, and specially customized ultra-low noise CMOS signal processing circuits, which greatly reduces The noise of the sensor is lower, the signal-to-noise ratio is obtained (about twice higher than that of similar competitors), and the measurement reliability of the ATP2400 is improved. The measurement results do not change with the ambient temperature, which is the best level in the industry. ATP2400 can receive SMA905 fiber input light or free space light, and output spectral data measured through USB2.0 or UART ports. ATP2400 only requires a 5V DC power supply or USB power supply, which is very easy to integrate. ATP2400 is a self-designed spectrometer that employs higher performance and smaller size vs USB2000+ ATP2400 has free SDK for customers self-developed, Optosky support C++, C#, Labview and Linux system SDK, which is very convenient for OEM customers to design solutions. The minim, ultra-thin, ultra-lightweight of a minim; Fiber input and signal output are on the same side, which is very easy to integrate. Detector: linear CMOS Detector pixel: 2048 pixels Ultra-low noise CCD signal processing circuit Maximum spectral range: 180-1180 nm (depending on requirements) Spectral resolution: 0.1-2 nm (depending on spectral range, slit width) Optical Design: cross-C-T Built-in pulsed xenon lamp driver Casual time: 0.1ms-130s Vinner power supply: DC 5V±10% or USB power supply A16 bit, 2MHz ADC Incident Interface: SMA905 or free space Supported data output interface: USB 2.0 (High speed ) or UART 20-pin dual-row programmable external expansion interface