Integrated chip spreader Spreadmaster

The Parker ‘Spreadmaster’ chipping spreader has been designed as the ultimate solution for surface dressing works. Controls have been centralised to simplify operation and minimise the time needed for driver training with a single joystick for all chip spreading controls and a steering wheel and accelerator to drive the machine. With a variable width twin section front aggregate hopper which is continuously expandable and a series of cut off gates the chipper is capable of spread widths of 300mm to 4.4m (12" to 174"). The Cummins Tier 4 Final / EU Stage IV Power Plant features a fully integrated aftertreatment exhaust system maximising torque output and fuel economy while acheiving near-zero emissions. Simple operating controls minimise time needed for operator training High travel speed between sites to reduce down time Accurate rate of spread of chippings without overlaps Spread widths from 300mm to 4.40 metres Efficient Tier 4 Final / EU Stage IV 194kW (260hp) engine with aftertreatment for near-zero emissions Four wheel hydraulic drive to cope with demanding terrain Travel Mode With front and rear hoppers fully retracted the machine has a travel width of 2.55 metres for movement between sites. Extending Spread Hoppers Right hand spreading hopper fully extended showing the feed roller and feed gate. Control Screen Control selection screen where the required parameters can be preset to enable operation using the joystick control. Road speed and spreading speed are automatically matched. Joystick Control The joystick which controls feed hoppers raise and lower, spreading on and off, spreading hopper extension and retraction and tow hitch operation.