Roller conveyor

horizontalVelectric drive

Jacking mechanism: welding type bottom frame with height adjusting foot, base type deceleration motor is placed in the middle of the bottom frame, two shafts are connected by bearing pedestal and bottom frame on both sides respectively, two shafts are connected with the motor by driving chain respectively. Each shaft and both ends are equipped with needle roller bearing crank arm to form the jacking structure. Load shifting mechanism: adopt chain machine, the specific structure is the same as the foregoing. Accessory device: photoelectric support (lift two positions, in place detection). Purchased parts configuration: reducer motor SEW, chain for hangzhou donghua, bearing with seat TR, ha shaft for bearing Surface coating: steel wire brush, sand paper are used to remove rust, acid wash to remove grease. After phosphating, the surface is sprayed with epoxy powder and baked. The thickness of resin is between 60 m and 90 m. • Double-sprocket roller （10A-13Z） • Φ76×3mm/Φ89×3mm • Side guide on roller • Side profile 125×70×15×5mm • R series gear motor Length （mm） 850 ≤ L ≤ 8000 Height (mm) H(min)≥380 Inner width B (mm) 620 ≤ B ≤ 1520 Motor power P (kw) 0.37～0.75 Conveyor payload (Kg) Max ≤1500Kg Pallet payload （Kg） Max ≤1200Kg