Conductive level switch RIL710 series

for oilplasticpolypropylene

The RIL710 Level Sensor is equipped with high-frequency technology, allowing reliable operation even for detecting an adherent electrically conductive medium. The sensitivity and modes (N.O. or N.C.) of the switches can be easily set by placing a magnetic pen on the sensitive spot. The output signal is either a transistor with an open collector (PNP) or a two-wire electronic switch (S). This connection is made using two wires directly to a circuit with a relay or to the binary input of a control system. The sensor is attached to the tube using two plastic clamps. The cable should be vertically oriented downwards. The maximum wall thickness of the tube is 8 mm. PRODUCT FEATURES Programming method - Magnetic pen Explosion protection - Safe zone Version - For pipes Mounting - On the side Measurement site - Bypass, Conduct, Tank Measurement type - With contact Storage temperature - -10...+70 °C Ambient temperature - -20...+90 °C Control points number - 1 Properties of the fluid - Viscous / Sticky, Non-conductive (µS / cm <20), Presence of suspended solids Area of use - For non-explosive atmospheres DETAILS OF THE SIGNAL INPUTS AND OUTPUTS Output details - 1 x Two Wire Switch ELECTRICAL DATA Voltage type - 24 Vdc Type of electrical connection - Cable Reverse polarity protection - No Status LED - YES Communication protocol - N/D Communication interface - None Electrical switch - 2-wire electronic switch or PNP (open collector) Number of electrical contacts - 1 Operating voltage - 6...30 Vdc MECHANICAL DATA Process connection type - Adhesive fixing to the tank wall Materials in contact with the measured fluid - N/D Height - 40 mm Width - 17 mm Depth - 14 mm