K111D is a frequency divider (capable of handling up to 256 pulses at the input) with the function of an input signal repeater. It has an isolated and stabilized power supply unit and front LED for power supply and outputs status. The galvanic isolation for signals originating from On/Off sensors is 1,500 V. The module accepts various types of input signals, with frequency up to 20 kHz, selectable for 2/3-wires sensors: NPN 12/24V, PNP, PNP 12/24V, photoelectric pulse, contact IEC 1131-1, Namur, Reed.
The 2 independent outputs are PNP high current outputs (up to 200 mA) with internal short-circuit protection. They can also be configured in divider or repeater mode. The module can be configured via PC using the S117P1 converter or via DIP switch.
Power supply on side clamps - Yes
Sensor power supply - Yes, available voltages 8V±0.6V, 12±1V, 22V±2V, max. current 22 mA
Hot swapping - Yes
Max absorbed current - < 25 mA
Max. power dissipation - 500 mW
Conversion A/D - 14 bit
Rejection - 50 - 60 Hz
LED - Power supply, outputs status
Configuration - via Software (EASY SETUP), via DIP switch
Input filter - Can be activated with programmable cut-off frequency
Insulation - 1,5 kVac (2 ways, input // output)
Insulation technique - Digital / Optocoupler
Elaboration - 32-bit floating point calculation
Communication port - 1 4pin frontal connector, pitch 2,54 mm
Accuracy class - 0,1%
Special functions -
Direct operation
Repeater
Frequency divider
Average measurement in a window of N pulses (N<=256)
Connection - Spring and/or Bus
Input channel - 1
Input type - Mechanical contact, contact IEC 1131.2 (type 1), Namur (DIN 19234, EN 60947-5-6),