Analog input module Z-SG3

Modbus RTUfor strain gaugesDIN rail

Z-SG3 is a load cell converter (strain gauge). The measurement carried out with the 4 or 6-wire technique, is available via Modbus RTU serial protocol and via the analog output. The instrument can directly power the strain gauge. EASY SETUP software manages The load cell calibration in the factory calibration or sample weight mode. Z-SG3 includes advanced functions (piece counter, automatic tare reset, threshold alarm, firmware automatically updatable) and flexible measurement management mode (measurements available in full and floating-point, measurement stabilized through noise filter, configurable resolution). The configuration is via software, while the baud rate and Modbus address are via the DIP switch. TECHNICAL DATA Power supply - 10..40 Vdc, 19..28 Vac (@50..60 Hz) Power consumption - 2 W Insulation - 1.500 Vac a 5 vie Accuracy class - 0,01% Status LED - Power supply Error Tx Data Rx Data Digital I/O Load cell overload Input channels - 1 analog channel for reading (and power supply) up to 4 (350 Ω) or 8 (1,000 Ω) strain gauge load cells, 4 or 6-wire connection, equivalent impedance 87 Ω 1DI tare calibration or weight threshold Output channels - 1 analog retransmission channel of the net weight in current (0...20, 4...20 mA) or in voltage (0..5, 0..10 V); 1DO tare calibration or weight threshold Advanced features - Tare acquisition Stable weighing signaling via Modbus Tara Silos function Counting function Tare reset function Data logging on EASY Setup Advanced settings - Analog output with programmable limits Upgradeable firmware I/O independent digital Wide-range settable sampling rate Alarm threshold with programmable hysteresis Fully configurable analog output