PVC structured fill block LTN-9601

for cooling towers

Marley MX75 cooling tower infill for crossflow cooling tower fill Marley MX75 cooling tower fill for crossflow cooling tower infill is a hanging film type cooling tower fill which spreads the water into a thin film, flowing over large vertical surfaces, promoting the maximum exposure to air flow. This cooling tower fill provides much more water surface exposure per cubic foot than the splash type fill. Marley MX75 cooling tower fill for crossflow cooling tower infill is thermoformed from PVC with a flame spread rating less than 25 per ASTM E-84 and is considered self-extinguishing. Therefore, the risk of fire damage is minimal. Marley MX75 cooling tower fill for crossflow cooling tower infill The efficiency of a cooling tower depends upon the cooling tower infill’s ability to promote both the maximum contacting surface, and the maximum contacting time between air and water. And it must promote this air-water contact while imposing the least possible restriction to the air flow. MX75 cooling tower infill is a hanging film type cooling tower fill which spreads the water into a thin film, flowing over the large vertical surfaces, promoting the maximum exposure to air flow. This type of cooling tower infill provides much more water surface exposure per cubic foot than the cooling tower splash fill. MX75 cooling tower infill incorporates highly efficient cellular drift eliminators, integrally molded within the cooling tower infill sheets. Compared with previous designs, these cooling tower eliminators reduce drift emissions from the tower by a factor of ten or more! Less drift means you could save on the water bills and water treatment chemical expenses.