Double scissors lift table HMD are used as elevated work platforms, lifters, feeding machinery systems, etc.
Features:
• - For E.2 models the load must be uniformly distributed, for A.2 models it can be partially concentrated.
• - Smooth upper surface sheet.
• - For E.2 models the maximum frecuency use is 15 cycles / hour, (shifts 8 hours / day). For A.2 models the maximum frecuency use is 10 cycles / hour, (shifts 8 hours / day).
• - Single acting lift cylinders.
• - Limit switch for the elevation.
• - Bearings auto-lubricated in the joints
• - Hydraulic power pack with safety valve to prevent overloadings and flow compensation valve to control the descent rate.
• - Keypad in fixed support over power pack unit.
• - Electrical equipment controlled electronically with transformer and thermal protection.
Optionally double pantograph tables may incorporate the following facilities:
• - Prepared structure to be moved by forklift
• - Special operating voltage (220V Mono, III 440 60 Hz, etc.).
• - Command from control panel, radio control or footswitch.
• - Surface floor of the platform in hot tear pattern sheet or inoxidable steel.
• - Certified ATEX for zones 1, 2, 21 or 22.
• - Extensible or collapsible lips (hydraulics or manuals).
• - Blockers system to allow people access to the platform.
• - Safety railings and extensible barriers.
• - Rotating plate above the platform (manual or motorized).
• - Tilting platform.
• - Motorized or manual roller conveyor.
• - Containment barrier for the load.
• - Shutters or sectional or hinged doors.
• - Bellows or protection curtains.
• - Special paint for exterior or marine environments.