Repair mortar

for concrete2-component

Tough repairs for concrete floors, steps and ramps Easy mix polymer and cement formulation Great value - only £4.88 per kg Covers approx. 1m² at 5mm thick Heavy traffic after only 4 hours Non dusting, resists grease and oil Repairs holes up to 100mm thick in one go Watco Basics Floor Repair Mortar can be used to fill holes in concrete inside and out. It is strong enough to resist heavy foot traffic, trolleys and trucks; (for areas where there is regular forklift traffic, we recommend Watco Concrex). Just take as much powder as you need out of the bucket, mix with water and trowel into place – you don’t need a primer. The mortar will not shrink as it dries and will take full traffic after only 4 hours. Floor Repair Mortar Recommended areas of use Damaged floors, ramps and steps, inside and out. Application Surface Preparation Only basic preparation is necessary. If the hole or patch to be repaired is just dirty and dusty, give it a good sweep. Watco Bio D can be used to remove oil and grease, or grease and loose material can be removed from small patches using a stiff broom or wire brush. Application It does not matter if the floor has been left damp following any wet preparation. Dampen dusty, porous surfaces with water in hot, dry conditions. The mortar can be applied at any thickness between 5mm and 100mm. For deeper holes build up in layers, allowing the first layer of 100mm to dry for 12 hours. If the edge of the repair is less than 5mm deep, chip some concrete away so that the edge of the mortar repair will be 5mm thick. For feather edge repairs which go to nothing please see Watco Concrex (epoxy resin mortar).