Actuator controller JCB35T2

· Outputs for actuator:1-4 · IP grade: Max. IPX6 · Power supply:SMPS • Power: input_100-240VAC, 50/60 Hz; The output power is 72W in the rated state, and the output power is 180W in the working mode • Power point light: Yes • Actuator interface: Maximum 4 channels, 6-pin ET bend plug • Handset interface: 1 channel, 10-pin crystal bend insert • Battery interface: 1 channel, 4-pin ET bend plug (output 30uA- when push rod does not operate) • Standby power: Max. 1W (230V) • Color: Grey • Control idea: H-bridge, the service life exceeds 20000 cycles (No relay noise) • Duty cycle: 2/18 @ 25°C; on/off continuous use (180W at 25°C for 120 seconds) • Weight:0.8kg • Actuator compatibility: signal switches(for signal switches) • Battery management: battery power can be turned off at low voltage, battery internal charge and discharge management • IP grade: Max. IPX6 • Operate: synchronous drive (no feedback) • Maximum current: 10A total for all channels • Power management: voltage management can ensure maximum power operation and limit output maximum power • Safety system: switching power supply thermal protection ,overcurrent protection • Position: Compatible with actuators equipped with special mounting brackets; bed frame • (via screws, sliding brackets) • Line card: all ports have