{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
Torque: 10 Nm - 2,400 Nm
Rotational speed: 2,800 rpm - 14,000 rpm
... minimum. Two styles of hub are offered: ‘A’ style with hub diameter reduced below flange diameter to minimise weight; and ‘B’ style with hub diameter basically the same as the flange diameter to accommodate ...
Cross & Morse
Torque: 250 Nm - 2,270,000 Nm
... , and minimal axial length. These clamping elements are basically to same design as RCK 13, but with increased diameter flange to locate hub and prevent axial movements, so combining good concentricity with positive ...
Cross & Morse
Torque: 264 Nm - 136,500 Nm
These clamping elements are basically to same design as RCK 13, but with increased diameter flange to locate hub and prevent axial movements, so combining good concentricity with positive axial location. The increase ...
Cross & Morse
Torque: 170 Nm - 1,943,000 Nm
Types RCK 19 & 20 are normally referred to as Clamping Discs, used to clamp externally onto thin walled hubs to lock them to the shaft. The design permits the use of large diameter shafts with small hub sizes, and is ...
Cross & Morse
Torque: 2,400 Nm - 3,736,000 Nm
... Wrench with these Clamping elements, just tighten the screws in clockwise sequence in stages until the front faces of the flange and outer ring are aligned. This allows the transmission of torque values shown in the ...
Cross & Morse
Torque: 12 Nm - 29,041 Nm
... design ensures good levels of concentricity. For correct operation of these units, the hub diameter should not be less than the flange diameter D2, even though with many materials stress limits would allow selection of ...
Cross & Morse
Torque: 45 Nm - 3,133 Nm
... design ensures good levels of concentricity. For correct operation of these units, the hub diameter should not be less than the flange diameter D2, even though with many materials stress limits would allow selection of ...
Cross & Morse
Torque: 1.5 Nm - 696 Nm
Rotational speed: 240 rpm - 700 rpm
... require an increase to the overall length of coupling in order to accommodate. Coupling and clamping element assembly are supplied to suit spécifie metric shaft sizes as indicated in the table. Clutch ...
Cross & Morse
Please specify:
Help us improve:
remaining