Cross & Morse rigid couplings

Torque: 250 Nm - 2,270,000 Nm

These are the original type of shaft clamping elements, proven in a wide range of applications for more than 20 years. Suited to more general applications, this series provides medium torque transmission, which can be increased by mounting ...

Torque: 282 Nm - 2,700 Nm

Designed for use with standardised ranges of pulleys, sprockets, and gears, the shaft clamping elements can accommodate a large range of shaft diameters with a hub of constant bore diameter. On clamping precise axial and radial positioning ...

Torque: 350 Nm - 193,200 Nm

These shaft clamping elements are very compact units capable of transmitting medium torques. Their design ensures good concentricity between hubs and shafts, without any other means of location. A slight axial movement between hub and ...

Torque: 264 Nm - 136,500 Nm

These clamping elements are basically to same design as RCK 13, but with increased diameter flange to locate hub and prevent axial movements, so combining good concentricity with positive axial location. The increase in friction between ...

Torque: 170 Nm - 1,943,000 Nm

Types RCK 19 & 20 are normally referred to as Clamping Discs, used to clamp externally onto thin walled hubs to lock them to the shaft. The design permits the use of large diameter shafts with small hub sizes, and is popular for connection ...

Torque: 2,400 Nm - 3,736,000 Nm

No need for a Torque Wrench with these Clamping elements, just tighten the screws in clockwise sequence in stages until the front faces of the flange and outer ring are aligned. This allows the transmission of torque values shown in the ...

Torque: 5 Nm - 2,019 Nm

Available for shaft diameters from 10mm, these clamping elements are designed for small low torque applications, providing concentric connection of components to shafting. The thin wall design combined with low hub pressures enable use ...

Torque: 290 Nm - 2,230,000 Nm

These are the original type of shaft clamping elements, proven in a wide range of applications for more than 20 years. Suited to more general applications, this series provides medium torque transmission, which can be increased by mounting ...

Torque: 80 Nm - 6,500 Nm

These clamping elements provide good torque transmission from a compact, low cost assembly. These units must always be installed inside the hub, and will then provide a reasonable level of concentricity. A small axial movement of the ...

Torque: 52 Nm - 1,433 Nm

These clamping elements use a single lock nut to apply the clamping pressure, thereby enabling quick assembly and removal. The lock nut can be secured in position by bending over a tab of lock washer. The thin walls of the clamping cones, ...