Ganter feet

Diameter: 24, 12, 18 mm

Stainless steel leveling elements GN 355.2 are used for levelling and adjustment in machines and equipment. They consist of a leveling screw, a socket cap screw with disk and a spherical washer. The leveling screw and spherical washer ...

Diameter: 40 mm - 119 mm

Levelling sets GN 360 are used for levelling and to compensate for any slope when setting up machines and systems. The fine thread allows precise adjustment and readjustment. The levelling sets are available with or without lock ...

Diameter: 50, 60 mm

... direction. The values listed in the table for static load capacity refer to a purely vertical load in relation to the leveling foot. Under normal operating conditions, bending loads or angular loads are not uncommon ...

Diameter: 160, 200, 80, 120 mm

Leveling feet GN 248 with damping element made of rubber are used to damp vibrations (oscillations) and shock movements. This has a positive influence on the life of a machine and helps to abate noise. Using the details on the maximum ...

Diameter: 80, 100, 125, 160, 200 mm

... through-hole allows the machine feet to be attached centrally to the ground, making them ideal for compressive and tensile loads. Foot plates and threaded studs are not connected together, during setup they are automatically ...

Diameter: 60, 80, 100, 120 mm

Leveling feet GN 17 are suitable for use in aggressive environments. The inclined surfaces for liquid runoff and the high surface quality of the base plate simplify cleaning and prevent the accumulation of dust or dirt. The FDA compliant ...

Load capacity: 3 t - 6 t
Diameter: 60, 80, 100, 120 mm

... without mounting holes are intended for use in hygiene areas. The bottom seal protects the area beneath the foot plate from dirt. For this, the foot must be screwed on using the mounting holes and compressed ...

Diameter: 6 mm - 20 mm

The Ganter in Furtwangen (Germany) provides a wide range of levelling feet, latches, as well as hinges. These are all built from steel, stainless steel, plastics or even a combinations like plastic/steel. Some of the levelling feet ...

Diameter: 25 mm - 60 mm

Levelling feet GN 839 are used for applications in cases where no jointed link is required between foot and adjusting screw. The cross slot drive at the underside has been designed for rapid pre-assembly. The value for ...

Diameter: 80 mm - 120 mm

Stainless Steel-Levelling feet GN 23 will be delivered mounted and are not removable.