OKS gear lubricants

Operating temperature: -50 °C - 120 °C

... with an automatic lubrication system. Relubrication intervals and amount to be defined acc. to the service conditions. If the removal of the old grease is not possible the amount of grease has to be limited to avoid excess ...

Operating temperature: -10 °C - 160 °C

... with an automatic lubrication system. Relubrication intervals and amount to be defined acc. to the service conditions. If the removal of the old grease is not possible the amount of grease has to be limited to avoid excess ...

Operating temperature: -50 °C - 130 °C
Pour point: -50 °C
Flash point: 200 °C

OKS 425 is a synthetic grease for long-term lubrication of machine elements. Advantages and benefits Good low-temperature behaviour, stress absorbing ability and smooth run at high speeds Good plastic compatibility The ...

Operating temperature: -15 °C - 160 °C

OKS 427 is a gear and bearing grease at high temperatures and high loads. Areas of application Lubrication of highly stressed and relatively slowly running gears where due to leakage ...

Operating temperature: -30 °C - 120 °C
Pour point: -45 °C
Flash point: 200 °C

... the amount of grease has to be limited to avoid excess lubrication of the gear. At longer relubrication intervals a complete exchange of the old grease is recommended. Mix with appropriate lubricants ...

Operating temperature: -25 °C - 150 °C

Silicone-free lubricant and sealing lubricant for plastic/plastic and plastic/metal combinations. Advantages and benefits Tasteless and odourless Consistent properties without drying out, hardening ...

Operating temperature: -45 °C - 120 °C

... grease for closed gears, rolling and friction bearings with minimal gearing play and high speeds, at low temperatures as well as low coasting torques. Areas of application For joints, propeller shafts and chains ...

Operating temperature: -30 °C - 220 °C

OKS 490 is a gear lubrication grease for open and half open gears. Areas of application For highest contact pressure and high circumferential speed, e.g. for rotary kilns, ball ...

Operating temperature: -30 °C - 100 °C

... an open gear spray for dry lubrication of slowly-turning, open pinion gears and steel cables etc. subjected to high pressures, dust or corrosive influences, such as outdoor weathering. Areas ...

Pour point: -30 °C
Flash point: 230 °C

... engine oils and 5-10% to machine- and gear oils. Instructions of the machine manufacturer have to be observed. Mixing will occur in operation. Only mix with appropriate lubricants. Not suitable with water-based ...