ROEMHELD clamping

... which the clamping bolt is safely engaged. This conical clamping bolt expands the hardened clamping bushing so that its points penetrate the bore surface in the workpiece with a positive ...

Clamping force: 1.3 kN

... for a hydraulic clamping element. In multiple clamping fixtures, the minimum distance between cylinders is 28 mm. A clamping recess in the workpiece a little bit wider ...

Clamping force: 2 kN - 22.8 kN

... Hydraulic swing clamps are used for clamping of workpieces, when it is essential to keep the clamping area free of straps and clamping components for unrestricted workpiece ...

Clamping force: 2.8 kN - 8.8 kN

... centre of rotation to the hydraulic piston the retaining force of a clamping jaw is three times higher than the clamping force. If only one clamping jaw acts at the workpiece, the clamping ...

Clamping force: 30.4 kN

The clamping element consists of a hollow-piston cylinder and a swing cylinder. The tie rod held in the hollow-piston cylinder is provided with teeth which engage in the toothed rack of the swing cylinder. The clamping ...

Clamping force: 60 kN - 412 kN

... ideal force transmission • compact design • clamping force from 60 kN up to 412 kN • high operating safety by position monitoring, emergency stop and overload protection • suitable for large clamping ...

Clamping force: 40 kN - 140 kN

... high-pressure spindle against the clamping edge, the drive spindle is operated by turning the hexagon nut. Thus, the clamping force is transmitted in axial direction to the clamping point ...

... single and double acting with protection against torsion, max. operating pressure 500 bar The hydraulic threaded-body clamping module pull-type was developed for screwing in into: • Standardized housings • Fixture ...

Clamping force: 0.6 kN - 7.9 kN

... , pull-type with and without centring function clamping for bore diameter 16 to 46 mm max. operating pressure from 50 up to 350 bar The bore clamp is particularly suitable for centring and clamping ...

Clamping force: 5.1 kN - 9.8 kN

... the clamping bushing are radially expanded with spring force by a conic clamping bolt. Thus the expansion force is always the same and independent of the hydraulic clamping pressure. ...