Seneca Modbus RTU input modules

... protocol MODBUS RTU through the RS485 serial interface. A 16 bit counter is available on each input, the maximum frequency input is 100 Hz and it is possible to set one ...

Z-10-D-IN is a module with 10 digital inputs, 16 Vdc self-powered common negative and removable terminals section 2.5 mm. Unlike Rev. Hw1, this module includes 10 inputs ...

... communicate by the protocols CANopen or ModBUS RTU (protocol selectable through dip-switch). It disposes of 32 bit counters (N.8), maximum frequency input is 10 KHz. A 3-way galvanic ...

... indication via Modbus register/digital output. Remote writing of the tare in volatile and/or non-volatile memory by digital input/Modbus register/Modbus commands. Z-PC-DINAL2-17.5, ...

... 1,5 kVac @ 6 way Data acquisition: - Every 25 ms Accuracy: - 0,1% Input: - CH-8 thermocouple type J,K,R,S,T,B,E,N or shunt up to 70 mV Communication: - RS485 2 wire, ModBUS RTU ...

Z-4AI is used to interface analog inputs (Voltage or current, also with bipolar range) with Modbus system. The modules is able to supply all 4 current loops at the same time, this is ...

The Z-8AI is used to interface analog inputs (Voltage or current, also with bipolar range) with Modbus system. The modules is able to supply all 8 current loops at the sameb time, this ...

... Ni100 with 2,3 or 4 wires) with four independent and isolated measuring channels. The module is characterized by a 6-way isolation up to 1.5 kV (Power supply // Single input channel (x4) // RS485 serial ...

... standard output signal. The number of input is 4 and each input is independent from each other. It’s a ModBUS Slave and can be coupled with any ModBUS Master device. ...

... as a standard output signal. The number of inputs is 8 and each input is independent. It's a ModBUS Slave and can be coupled with any ModBUS Master device. A 6-way galvanic ...