Seneca RS485 input modules

... MODBUS RTU through the RS485 serial interface. A 16 bit counter is available on each input, the maximum frequency input is 100 Hz and it is possible to set one input ...

Z-10-D-IN is a module with 10 digital inputs, 16 Vdc self-powered common negative and removable terminals section 2.5 mm. Unlike Rev. Hw1, this module includes 10 inputs ...

... selectable through dip-switch). It disposes of 32 bit counters (N.8), maximum frequency input is 10 KHz. A 3-way galvanic isolation among Power supply // input // RS485 circuits assures ...

... to different groups of terminals: the module has total isolation of six points. This laboratory version, compared to the more well-known Z-8TC-1 converter, is characterized by two-way terminals and the same input ...

... galvanic isolation among Power supply // input // RS485 circuits assures the integrity of your datas. Power Supply: - 10..40 Vdc, 19..28 Vac Auxiliary Sypply: - Up to 8 current loop Insulation: ...

... or 4 wires) with four independent and isolated measuring channels. The module is characterized by a 6-way isolation up to 1.5 kV (Power supply // Single input channel (x4) // RS485 serial ...

... output signal. The number of input is 4 and each input is independent from each other. It’s a ModBUS Slave and can be coupled with any ModBUS Master device. A 3-way galvanic isolation among Power supply ...

... standard output signal. The number of inputs is 8 and each input is independent. It's a ModBUS Slave and can be coupled with any ModBUS Master device. A 6-way galvanic isolation among Power supply // ...

ZC-8AI is used to interface analog inputs (Voltage or current, also with bipolar range) with the CANopen system. The module is able to supply all 8 current loops at the same time, this is very useful ...

... ,3 or 4 wires. The number of input is 4 and the each input is independent from each other. It’s a CANopen device and can be connected into a CANopen network. A 6-way galvanic isolation among Power supply ...