TOTAL LUBRIFIANTS metalworking oils

Flash point: 180, 200 °C

... Improvement to operators health due to almost no carcinogenic compounds as polycyclic aromatic hydrocarbons present in the oil. Reduced oil mists and less product consumption through evaporation, due ...

Operating temperature: -3 °C - 240 °C

... cutting lubricant VALONA MS 7010 BIO is a vegetable oil cutting oil designed for turning, drilling, tapping, grinding and honing on ferrous and non ferrous metals. VALONA MS 7010 BIO is a neat cutting ...

Flash point: 306, 314 °C

Good seals compatibility. High ignition point. Very high lubricating power ensuring a very tough oil film at high pressures and temperatures. Very high resistance to water washout.

Pour point: -24 °C
Flash point: 284, 272, 248, 238, 244 °C

The properties of DACNIS : - avoid the carbon build up - allow a good oil/air and oil/condensates separation - protect components against wear and corrosion. The use of DACNIS allows real ...

Pour point: -33 °C
Flash point: 238 °C

... of use, - reduction in the formation of carbonaceous deposits, - better oil/air and oil/condensates separation to prevent formation of emulsion and protect the air/oil separating ...

Pour point: -57 °C
Flash point: 268, 262, 246 °C

Rotary screw-type air compressors. The properties of DACNIS SH: - avoids the carbon build up - allows a good oil/air and oil/condensates separation - protects the screws against wear and corrosion. The ...

Pour point: -30 °C
Flash point: 220, 205, 200, 185 °C

... stability with refrigerants. Absence of copper plating. Very good miscibility behaviour with refrigerants allowing a good oil return to the compressor (evaporator temperature higher than - 15 °C).

Flash point: 256, 246 °C

... LUNARIA NH oils : oil consumption is reduced by 30 to 50 % compared with conventional oils. Good compatibility with common elastomers (chloroprene, NBR….). Warning : storage must ...

Pour point: -57 °C
Flash point: 278, 268 °C

... LUNARIA NH oils : oil consumption is reduced by 30 to 50 % compared with conventional oils. Good compatibility with common elastomers (chloroprene, NBR….). Warning : storage must ...

Flash point: 200, 210 °C

... behaviour with refrigerants allowing a good oil return to the compressor (down to – 60 °C at the evaporator). CAUTION : Deposits may clog filters when shifting from a mineral oil to a synthetic alkylbenzene ...