Tsubaki shaft couplings

Torque: 196 Nm - 173,000 Nm

It is the most popular global standard model. ・Many manufacturers are available both domestically and abroad, and this series is highly compatible. ・The large taper angle makes it easy to tighten and remove. ・The easiest to handle ...

Torque: 382 Nm - 429,000 Nm

... replace AS Series units. ・Only Tsubaki products are available from Φ19. Large capacity torque transmission for small diameter shafts should be left to. Electroless nickel plated ・The units are plated with peel-proof ...

Torque: 5 Nm - 9,900 Nm

With a lineup from small diameter shafts, it can be used for a wide range of shaft tolerances. (Other than KE-KP ) ・Designed to suit a wide range of shaft tolerances Standard models ...

Torque: 265 Nm - 27,000 Nm

... for the hassle of machining on hubs for guide portions. ※There is no hub movement when assembling. ※In the case of step shaft installation, make sure the space between the hub and the steps is greater than 1 mm. Standard ...

Torque: 11 Nm - 8,820 Nm

Suitable for small hub applications with the small inner-to-outer diameter ratio. ・Designed to fit small hub diameters with the smallest available inner-to-outer diameter ratio of our Power Lock series. ・Minimum number of locking bolts ...

Torque: 5 Nm - 1,170 Nm

... coating is applied to the locking bolts, so no additional lubrication is necessary during assembly. ・Available from small shaft diameters. Provides more transmission torque than the KE-SS Series.

Torque: 167 Nm - 290,000 Nm

... for hollow shaft connections such as reducers. ・It can be used where design limitations force the use of thin-walled hubs. ※There is no hub movement when assembling. ※When used for a hollow shaft, ...

Torque: 6.76 Nm - 2,000 Nm

... connect with a single nut. ・Can be easily locked with a single nut. Installation time can be significantly reduced. ※ML type for shaft diameters up to Φ32 and MG type for Φ34 and over, and appearance also differs. ※With ...

Torque: 6.9 Nm - 10,500 Nm

The simplest element type allows for optimal design. ・Compact and lightweight. Requires a minimum of installation space. ※The pressure flange, pressure sleeve, and locking bolt must be prepared by the customer. ※Outering pressurize ...

Torque: 39 Nm - 12,600 Nm

A pressure flange integrated type with the same inner and outer diameters as the EL series. ・The EF Series, designed with the same inner and outer diameters as the EL Series, integrated pressure flange saves you the hassle of making ...